Jump to content
SAU Community

Recommended Posts

  • Replies 47
  • Created
  • Last Reply

Top Posters In This Topic

i say: "meh"

agreed!

they already said that the possibility of a tsunami hitting the coast of Northern QLD is very unlikely, let alone hitting the NSW coast, but need to issue the warning because it's still possible.

Link to comment
https://www.sau.com.au/forums/topic/162826-tsunami-warning/#findComment-3022556
Share on other sites

$10 says its a fizzer

The NSW State Emergency Service advises that:

· People at the beach should probably have sand castle building competitions also maybe bury each other up to your heads in the sand.

· People in boats in shallow water should immediately start drinking champers. It'll be an awesome adventure of alcohol and tidal waves.

· Boats and ships at sea should move to shallow water and aim for beach goers.

· · If you see the sea go out like a very low tide then immediately go to the shore and take a closer look. Its an phenomenal site to see and the closer you are the better.

· People should keep listening to the local media for updated information so they can use this event as an excuse to get off work for a day.

This warning will be updated by 1pm EST.

Link to comment
https://www.sau.com.au/forums/topic/162826-tsunami-warning/#findComment-3022701
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Thanks for that mate always a good help
    • It's not really a calibration issue, if the voltage is really at 2V. If the voltage is 2V, then that's what the TPS is putting out, and the Haltech is seeing that and 2V is about 40% open (you know, between 0.45v being closed and something close to 4.5V being fully open). So, that would suggest that the TPS is maladjusted, on crooked, something something something. Or a wire problem.
    • Hi guys my TPS voltage is reading over 2v at idle.  My Haltech ECU is reading around 40% throttle position at idle also which is really strange. Note the actual throttle position sensor is brand new…    anyone have any experience with this or know how to calibrate it on Haltech ? 
    • The OEM disk will not work on any AEM ECU, you need to use the one they made. You shouldn't have to flip the CAS or whatever you were describing, if you set the ignition sync offset correctly it can't backfire. Make sure you're using a spark plug lead on coil 1 instead of the timing loop to avoid weird issues with the timing light. Double check that your timing settings are actually correct, like is the 24 tooth configured correct or should it actually be 12 teeth for 1 crank revolution? I also found this: 305817248-AEM-Undocumented-Settings-v1-2.pdf    
×
×
  • Create New...