Jump to content
SAU Community

Recommended Posts

I'm assuming you DO want more top end power than the stock turbo??

because you wont beat the stock turbo for response. :/

other options like a highflow rb25 turbo (ie. GCG) might be the way to go, steel wheels etc. and similar response to stock...

but in short, Nissan lightened the stock turbo by using plastic/nylon and ceramic components. It means it wont last as long and cant take much boost (1 bar is enough to kill it very quickly) but if the car is left stock and not thrashed it would probably suit it just fine.

If you want more power than the stock turbo can give you, there will likely be some compromises and one of those will be slightly less response/more lag.

You can still keep turbo lag pretty close to stock however...just not exactly the same ;)

gcg is garret is it not? correct me if im wrong thats just what i thougth it was. but dnt for get slideingperformance on these forums he does highflows for like 1200ish i think.

garrett an gcg are to different companies,garrett does there hi-flow for about $2200,gcg does there's for about $1700,garrett has a lot better/stronger components in side there turbo,i did a little custom work for garrett in december,

HKS GT2530 for the win. :ermm: Blistering response, I think it would be just the same as stock turbo if not better. But it does run out of air up top, I think from research it dies from ~-5500rpm, but that saves you having to go to redline all the time.

Just for an opinion, I just installed a GT-RS and running on just the HKS actuator I can't tell a difference between the stock turbo with tuned EBC and the GTRS in terms of lag.

garrett an gcg are to different companies,garrett does there hi-flow for about $2200,gcg does there's for about $1700,garrett has a lot better/stronger components in side there turbo,i did a little custom work for garrett in december,

So what is actually stronger? Because to me that sounds like a pretty incorrect statement

The GCG uses:

Garrett cartridge

Garrett wheels

Factory machined housings

The Garrett item uses

Garrett cartridge

Garrett wheels

Factory machined housings

So what parts are actually left that are different? None.

That to me suggests they are (component wise) the same thing.

Ignoring the actual spec of the turbos which is irrelevant when we talk strength of components.

The TD05 is a bitch to fit, but for what its worth - its a fair bit better than the stock R33 turbo.

A mate of mine runs a TD05 16G from an EVO 3 on his RB20DET. It DOESN'T spin the "wrong" way, has a single pulse turbine housing, spools about the same on the RB20 as R33 turbos spool on RB20s - but flows an absolute crapload better up high. It hit ~200rwkw without trying too hard....

They run a much larger turbine wheel than R33 turbos, and a slightly bigger compressor wheel - I'd say they'd have to be easily comparable with an HKS GT2530 in terms of power and spool.

The TD05 is a bitch to fit, but for what its worth - its a fair bit better than the stock R33 turbo.

A mate of mine runs a TD05 16G from an EVO 3 on his RB20DET. It DOESN'T spin the "wrong" way, has a single pulse turbine housing, spools about the same on the RB20 as R33 turbos spool on RB20s - but flows an absolute crapload better up high. It hit ~200rwkw without trying too hard....

They run a much larger turbine wheel than R33 turbos, and a slightly bigger compressor wheel - I'd say they'd have to be easily comparable with an HKS GT2530 in terms of power and spool.

It should be the same as a GT2835 with the .48 A/R in terms of power if it's from an EVO 3

  • 2 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...