Jump to content
SAU Community

Recommended Posts

HI THERE,

JUST AFTER SOME PART NISSAN PART NUMBERS FOR A R32 GTR 90' MODEL.

1. THE RUBBER SEALS WHICH GO AROUND YOU ROCKER COVERS - PRESUME THEY MAY COME AS A KIT BUT COULD BE WRONG ON THAT ONE? AND

2. THE REAR GEARBOX RUBBER MOUNT, (HOLDS THE GEARBOX AT THE RIGHT HEIGHT BETWEEN WHERE THE BAR GOES ACROSS THE CAR IN THE MIDDLE AND THE BOTTOM OF THE REAR OF THE GEARBOX).

MANY THANKS IN ADVANCE!

ADRIAN. >_<

HI THERE,

JUST AFTER SOME PART NISSAN PART NUMBERS FOR A R32 GTR 90' MODEL.

1. THE RUBBER SEALS WHICH GO AROUND YOU ROCKER COVERS - PRESUME THEY MAY COME AS A KIT BUT COULD BE WRONG ON THAT ONE? AND

2. THE REAR GEARBOX RUBBER MOUNT, (HOLDS THE GEARBOX AT THE RIGHT HEIGHT BETWEEN WHERE THE BAR GOES ACROSS THE CAR IN THE MIDDLE AND THE BOTTOM OF THE REAR OF THE GEARBOX).

MANY THANKS IN ADVANCE!

ADRIAN. >_<

please look at this and tell me that these are the parts you need. i will supply you with part numbers if they are.post-14067-1186364698_thumb.jpg

i haven't been able to find the gearbox mounts. i do know that you can get the nismo 1s from justjap. Gearbox mounts

maybe arbess will be able to find the genuine 1s for you.

1990 R32 GTS4

drivers side propella shaft rubber boot (shaft to front diff housing)

Picture added to help clarify the part:

post-32703-1186319346_thumb.jpg

im not sure what part your after. i dont know of any rubber boots like that on the front driveshaft. steering rack maybe?

please look at this and tell me that these are the parts you need. i will supply you with part numbers if they are.post-14067-1186364698_thumb.jpg

i haven't been able to find the gearbox mounts. i do know that you can get the nismo 1s from justjap. Gearbox mounts

maybe arbess will be able to find the genuine 1s for you.

Yep, those are the two gaskets i'm chasing which you have highlighted in green would there be any chance you could get the part numbers for these that i have to go to Nissan with to order them direct - i was also going to chance the half moons whilst i was in there replacing the rocker gaskets - so the parts i'm chasing are:

1 x 13270

1 x 13270 + A

2 x 11051H

I'll also grab that gearbox mount from justjap so thankyou very much for the link to that page, it's greatly appreciated!

Many Thanks,

Adrian aka skysaresilver

Yep, those are the two gaskets i'm chasing which you have highlighted in green would there be any chance you could get the part numbers for these that i have to go to Nissan with to order them direct - i was also going to chance the half moons whilst i was in there replacing the rocker gaskets - so the parts i'm chasing are:

1 x 13270

1 x 13270 + A

2 x 11051H

I'll also grab that gearbox mount from justjap so thankyou very much for the link to that page, it's greatly appreciated!

Many Thanks,

Adrian aka skysaresilver

1 x 13270 = 13270-58S01-

1 x 13270 + A = 13270-58S11-

2 x 11051H = 11051-58S00-

>_<

hey mate

just after part numbers for R32 gtst 93

idler pulley

tensioner pulley

water pump

timing belt

are these part numbers the same as a r33 cause i've heard they are the same

thanx

21010-70T25 - RB20DET water pump (or try 21010-42L25)

13028-20P25 - RB20DET timing belt

13074-58S00 - RB20DET idler pulley

13070-53L00 - RB20DET tensioner pulley (or try 13070-73L00)

Water pump is approx $110 retail from Nissan

You are better off getting some Gates or CBC bearings/pulleys as OEM you can expect to pay $250+ for each

Autobarn for eg, can order in a kit for you fairly cheap and it also includes the oil seals, but CBC bearings are better quality and a little more expensive (still cheaper than Nissan though)

Also the Gates Racing timing belts are about the same price as a standard OEM belt

Are you doing the 100k service?

you are a legend :P

I'm trying to find a noise and had to take my balancer off in the process so i thought I might aswell do it again. maybe if i'm lucky it will get rid of the noise too.

nah not going to nissan. bearing industries couldn't find the part number for rb20's.

thanx heaps :thanks:

thanks mate for the info.. :D

No probs. ;)

need part number for a o2 sensor for a '95 model series 2 rb25det?

R33 RB25DET 02 sensor part numbers:

08/1993 - 11/1993 number : 22690-21U00 (alt number 22690-83T10)

11/1993 - 01/1996 number : 22690-83T10

01/1996 - 11/1997 number : 22690-83T10 (same)

11/1997 - number : 22690-83T11

Edited by FighterJoe

Excellent thread! :D

I need some help also for the following:

1996 R33 GTR

BCNR33-024671

Injector sealing O-rings

Intake Plenum Gasket

AAC Valve Gasket (maybe the same as this? 23785-40F00)

Driver Door Seal

Passenger Door Seal

And finally... the little GTR Square plug that goes by the coin holder on the center console behind the shifter boot.

Thanks in advance. ;)

David.

Excellent thread! :D

I need some help also for the following:

1996 R33 GTR

BCNR33-024671

Injector sealing O-rings

Intake Plenum Gasket

AAC Valve Gasket (maybe the same as this? 23785-40F00)

Driver Door Seal

Passenger Door Seal

And finally... the little GTR Square plug that goes by the coin holder on the center console behind the shifter boot.

Thanks in advance. ;)

David.

For BCNR33-024671 (Nov 1996)

Injector sealing O-rings - Insulator-injector number: 16636-V5000

Intake Plenum Gasket - Intake manifold gasket number: 14035-05U10 (assuming intake manifold gasket not throttle chamber gasket which is 16175-05U70)

AAC Valve Gasket (maybe the same as this? 23785-40F00) - AAC gasket number: 23785-40F00 (yep same as the one you quoted)

Driver Door Seal - Right hand door weather strip number: 80830-22U00

Passenger Door Seal - Left hand door weather strip number: 80831-22U00

the little GTR Square plug that goes by the coin holder on the center console behind the shifter boot - Switch hole mask number: 68960-24U00

Edited by FighterJoe
For BCNR33-024671 (Nov 1996)

Injector sealing O-rings - Insulator-injector number: 16636-V5000

Intake Plenum Gasket - Intake manifold gasket number: 14035-05U10 (assuming intake manifold gasket not throttle chamber gasket which is 16175-05U70)

AAC Valve Gasket (maybe the same as this? 23785-40F00) - AAC gasket number: 23785-40F00 (yep same as the one you quoted)

Driver Door Seal - Right hand door weather strip number: 80830-22U00

Passenger Door Seal - Left hand door weather strip number: 80831-22U00

the little GTR Square plug that goes by the coin holder on the center console behind the shifter boot - Switch hole mask number: 68960-24U00

Hey just me again,

Thanks once again for the part no's you were able to get for me last week they were tops and i ordered and fitted the parts from Nissan on the weekend!

Just another quick question for the Injector Sealing O-rings are they the same part on the r33 gtr as on the r32 gtr, (16636-V5000) or another no altogether, and are they the seal between the fuel rail and the injector head? As that's the part i'm after!

Many Thanks once again,

All your help here with Part #'s is excellent!

skysaresilver

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...