Jump to content
SAU Community

Recommended Posts

Firstly, i know this is in the wrong section but i need an answer by tomorrow and there was only one person reading the suspension, breaking and tyres thread.

I'm buying new tyres tomorrow and i want to know if fitting a 225/50/R16 tyre on stock 6" wide R32 GTS-T wheels is overkill?

Will i get more grip or just more sidewall flex as apposed to a 205/55/R16 tyre which are fitted at the moment?

Should i just stick with the 205's?

Link to comment
https://www.sau.com.au/forums/topic/178383-sacrificing-sidewall-flex-for-grip/
Share on other sites

is it going to be for track drag use? if yes then go the 225's. is street/track then go 205's or 215's. i ran 225's on my stock 33 wheels and didn't really notice a difference. they gripped a bit better and didn't really notice any sidewall flex when cornering, but that was only street use.

Firstly, i know this is in the wrong section but i need an answer by tomorrow and there was only one person reading the suspension, breaking and tyres thread.

I'm buying new tyres tomorrow and i want to know if fitting a 225/50/R16 tyre on stock 6" wide R32 GTS-T wheels is overkill?

Will i get more grip or just more sidewall flex as apposed to a 205/55/R16 tyre which are fitted at the moment?

Should i just stick with the 205's?

225 tyres will be to large for any type of track work....unless it is for drag.

205/45/16 are the way to go on 6 Inch rims for your car.....remember wider is not always better.

EDITED..Sorry..I meant 205/55/16..Cheers

--------------------------------------------------

Your side walls will hold in corners with this size.

Also if you forget to pump up your tyres and run lower pressure for a while with the 225's your side wall corner tread

will wear quickly and you will have to run...high pressures after to try and even them out.

Don't forget also...some tyre manufacturers under state the widths..so also depends on the make.

I've had some weird and wacky combinations in the past on my car. For a long time I was running 215/60/15 on the stock SR rims (5.5"). The tyres looked very bulgy, but did quite a few mountain drives / skid pan sessions and never had a big problem with flex plus the grip was amazing.

I am now running 225/50/16 on R32 rims on the arse end, and it does not look nearly as bulgy as the above combination was. I am going to give it a go at the track next weekend as two of my semi-slicks have had it and the other two tyres that I have aren't nearly grippy enough.

ps. If you go to this site: http://www.1010tires.com/TireSizeCalculator.asp and type in the two tyres sizes you are comparing, you will see that the 225/50/16 combination is recommended for rims that are 6-8.5" wide.

Edited by Thunderbolt

you could always try and get yourself a set of 300zx rims. they are about a 7.5" rim, so you could run 225/50/16s and not worry about flex.

205/45/16 are the way to go on 6 Inch rims for your car.....remember wider is not always better.

you would also have to take into account what the track is like. if it is rough the smaller sidewall of these tyres is going to make it rougher, and it will alter your gearing slightly, since the stock size has a higher profile, at 55.

at the end of the day tyre compund is going to have the biggest affect on grip. if you get a set of hard tyres they won't grip as well as a set of sticky tyres. a set of 195 semi slicks will out perform crappy, hard 245's.

I'm running 225's all round at the moment, and prior to that, was running 205's all round.

The launching traction was noticeable but the sidewall flex pissed me off when in the twisties. I'm going to run 205's on the front and 225's on the rear next time.

For circuit work you need to know the actual tread width of the tyre, not the numbers, in order to make an informed choice. Rim width should equal or be up to 30mm wider than the tread width.

Hey guys, thanks for the replies.

I should have specified that the tyres were for the rear only. I had previously ran 205's on the front and 225's on the rear but decided this time to go with 205's all round.

I ended up buying Continental Tyres. Has anyone else used these before? I was a bit sceptical as i haden't heard alot about them but they are of excellent quality and cars such as BMW and Mercedes come with them fitted from factory. They're very big in europe.

They were $285 a tyre, marked down to $185 each on special and i got a deal so i got them for $175 each or $350 for both.

I mentioned sidewall flex in terms of drifting. I'm hoping to enter in a Winton practice day the one after the kamakazi battle. I have a set of old 205's and a set of old 225's so i will be able to find out first hand the amonut of sidewall flex i do get if any.

Cheers.

Those Continentals looked perfect fit in 205's.... I dont think there was any real issue when you were running 225's on the rear for the street but when you go to winton i would just be using the 205's.

From my personel experince stretching the tyre just a bit (235 on a 9" rim) made a noticable difference from my street 255's. It felt much nicer overall. I would like to test a 225 on my 9" but the 235's are so easy and cheap to get my hands on.

Also different tyre brands vary so much - 235 bridgestone is more stretched than say a 235 nankang etc. for example

Might be worth trying a 195, 205 and a 225 before the track day to see what feels right?

Or buying some wider rims :(

Well I thought I would give some feedback after running 225/50/16 on the rear of the car on the track today. I didn't notice any flex at all, however the tyres didn't grip as nicely as I would have liked. It was probably made more noticeable because I was running semi-slicks at the front.

depends on brand....

some brand will have a stiff enough sidewall that it wont matter, whereas some are really soft and allow the tyre to move more.

but its better to have a correct sized tyre. so 205 is a better fit.

  • 1 month later...

This may seem silly. What is the difference in profile between 50 / 55 / etc? Does a bigger number mean that the verticle height of the tyre is higher? Does a smaller number mean that the overall diameter of the tyre is smaller?

yeah 55 is higher than 50 for the same width, but the even sillier thing is its not 5mm or 5cm or anything like that. It is the height of the sidewall as a % of width.

so a 265/35/18 is about the same height overall as 235/45/17. there are calculators around to calculate equivalent sizes

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi from Canada, Both of my calipers are starting to fail. My car is a 2005 M35 Stagea ARX and I can't seem to find any parts or any cross reference caliper that would fit my car. Is there a company or a similar caliper that would fit and I could replace the OEM one. Or if anyone knows where I can find a new OEM. Any help is very appreciated. Let me know!
    • Maf is a question mark but TPS  I have set at 0.47, the fact that I’m getting proper voltage range out of it with the key on leads me to believe it’s functioning properly. I’m getting proper voltages on basically everything. I still need to look up voltage ranges for z32 maf and test that 
    • Honestly no not at all, but it’s a very basic tune, it’s stock injectors q45 tps and z32 maf. Other than that it’s a completely stock base map. The file is from nistune and from my understanding if it was tune related I would be able to unplug maf and tps and it would still start even if it was a really shitty start. I have tried starting it with coolant temp, maf, and tps unplugged none of those 3 togethor or individually changes anything 
    • 🏆 Skyline Supremacy Meets Mount Panorama Magic 🏆 Join SAU NSW as we take the long way to Bathurst, the home of GTR greatness. Saturday 30th August 2025 7:00AM Meeting Hanna Park North Richmond 7:30AM Departure Cruise Via Bells of Line Road 9:00AM Arrival to Stop 1: Golden Poplars Meadow Flat 9:45AM Arrival to Final Destination: Mount Panorama Motor Racing Circuit Meet Location: Hanna Park North Richmond Stop 1: Golden Poplars Meadow Flat Final Destination: Mount Panorama Motor Racing Circuit   *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • What does it look like with highway driving? And yes, I had a similar thought as Duncan. It looks quite similar in my Stagea and I have made myself accept it as normal. Might have to look into it some day   Highway gets as low as 10l/100km on my end so I'm not as worried about it being a mechanical issue. More likely just the tune on the haltech.
×
×
  • Create New...