Jump to content
SAU Community

Recommended Posts

If it's the same one i'm thinking of, it has 20's and the front bar has been cut out big time.

Its got some kit on it. Didnt look too bad, but WAY too low, and WAY too big wheels, and its slow.

At Carindale, near the escalators down near Laura Asheley.. you were talking towards the post office

Oppps...sorry I'm sure I wasn't staring, just not tuned to watch out for skylines when inside a shopping center! :P

yea, saw it tonight. i only got a quick look, but i was amazed. i never thought id see a middle aged women driving a modded gtst r33. nothing wrong with it, just unusual.

cool.

yeah it's been around for a bit. good to see a few more ladies owning skylines.

spotted a white 4 door r32, i think u honked at me twice, was on anzac avenue redcliffe headng towards rothwell.

also on anzac avenue, a black r33, u showed off ya blow of vavle a few times :blink:

and finally, another black r33, u follwed me from anzac avenue, all the way to the sea front,.

YAY!

Can you get us cheap stuff!?

Yeah... Find it and ill do it as cheap as possible for ya....

Call 3834 1100 ask for Colin

Is that a Factory yellow Col?

No not factory its dulux base yellow, was painted 12 months ago now....

Makes it easy when i need to touch up bits....

Panel beater says: What colour is it...?

Col says: Yellow

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...