Jump to content
SAU Community

Recommended Posts

Saw a silver S2 33 last night just before the defect stop on anzac ave he did a u turn at next possible location and I followed suit. Shouldve pulled into the maccas there and had a chat with him :(

so today I spotted that same Red r33 with gtr wing in Ipswich

then on the way home I seen it........the holy grail (for me at least and ford fans........

just mincing along between gold coast and brissy. Still on Texas plates a Shelby GT 500 super snake.......

I nearly tripled my self....... the sound, the look, the stance

tripling : http://www.urbandictionary.com/define.php?term=Tripling%20Yourself

so today I spotted that same Red r33 with gtr wing in Ipswich

 

then on the way home I seen it........the holy grail (for me at least and ford fans........

 

just mincing along between gold coast and brissy. Still on Texas plates a Shelby GT 500 super snake.......

I nearly tripled my self....... the sound, the look, the stance

tripling : http://www.urbandictionary.com/define.php?term=Tripling%20Yourself

We had a gt 500 parked out the front of work a few months ago. Plates were SNAKE II. it was in mint condition and sounded spectacular, especially with the faint supercharger whine.

We had a gt 500 parked out the front of work a few months ago. Plates were SNAKE II. it was in mint condition and sounded spectacular, especially with the faint supercharger whine.

you can hear every single one of the horses. and this ones whine wasnt faint

  • Like 1
  • 2 weeks later...

seen a very sic r35 when crusin in the city saturday night, looked to be a light silver possible metallic white colour if thats possible?? bloody hot looking car non the less!! plates 8mycsh or 8mycash forget which one to busy admiring.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...