Jump to content
SAU Community

Recommended Posts

My Filtermag arrived today from the USA, probably not really worth posting about, but since I wasnt able to find one in Australia I figured I would anyway. The concept is that your oil filter cannot phyically filter out all of the metal shavings produced as part of engine operation. If it could, the filter would have to be so fine that Oil itself couldn't pass through. Instead, the fine iron particles are attracted to the the magnet and removed from the oil circulating through your engine. I tested it on a spare oil filters in the garage and damn it's a powerful mofo! once that b1tch is on it won't come off too easily!

Has anyone else tried them out? Comments?? etc?

cimg1542bh6.jpg

So this goes AROUND the outside of the line or something, still leaving the metal in there, just collecting enough of it together, that when you finally take it off, you have a ball bearing of metal ready to be sent through your engine? Or if you leave it on, you have a clog...

Is this correct?

Cause if it is, it sounds like fun :(

I'm guessing it would accumilate in the filter, then when u change filter take it off and turf the shrapnel with it, then put it over the new filter.

Good idea.

Haha well I bought it specifically for whilst running in my new motor, I also have a magnetic sump plug, the g/f's dad has one one of the plugs his Gen III which picks up alot of cr@p too.

Edited by MintR33

Sure mate, I got it from ebay off this guy: Ebay Member

And the product website is: www.filtermag.com

If I remember correctly the website has alot of pics of filter's cut in half... take them as you will, no doubt they only posted pics with the largest build up of fine iron, but in all honesty I can't see how it wouldn't work, since the dirty oil passes through the outside of the filter past the magnet before being pulled through the filter core. I've also heard that the A'PEXi UFO filters use a magnet aswell. The benefit of this one is that you can swap ot over to your new filter with every oil change.

not a bad idea on a new engine since everything is wearing in but i see it doing close to nothing on a engine that was already "run in".

If your engine was turning around metal that is able to be picked up by a magnetic, you have more things to worry about than oil filtration.

SnakOil my ace, ppl run magnetic sump plugs for the same reason. Here you have much more powerful rare earth magnets (i would assume) right where the oil is already turbulent and full 'o' eddys.

Check the site, theres something being picked up by the magnet thats gettn by the filter.

These are absolute gold, one of those "cant believe i didn't think about that" ideas thats cheap as a blowjob. CRD and some other shops incidentally have been running them on thier cars for a while.

Edited by GeeTR

GReddy also make an Oil Filter that has a magnet built in. I have been using these for quite a while, however as far as I'm aware they are being discontinued so this might be the next step for me.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
    • Ah coolant overflow, previous discussions make way more sense now lol. 
×
×
  • Create New...