Jump to content
SAU Community

Recommended Posts

Spotted Damo just then along Grand Junction Rd near Foodland.

Just spotted 120+ dudes on trail bikes cruise past in balgowan... made me weekend..

hopped in the gtr and chased em down, spoke to the bloke who was closing the gate to an offroad pass - they were from port pirie MC club, doing their annual run.... were u there ruby? was great standing out the front and sipping my drank watching them all cruise pass... most were covered in dirt so u know that they were riding hard along the beaches...

also saw a very nice black R33 in ardrossan, a 2 door coupe, not sure what model... howdy if you're reading!

using nextG inet via my phone ; its not bad but not awesome. 50k a sec xfer but sadly loads of disconnections, and thats with a 4/5 bars from NextG base station....

still i aint complaining, im loving the connectivity...

D

Spotted Damo just then along Grand Junction Rd near Foodland.

Spotted :(

Also spotted Danai in stealth mode in the VT commodore on Port Rd

Spotted a chick in a silver 4 door 34 with bodykit while i was out washing the 34 on the front lawn. I used buckets, i swear :laugh:

Spotted :P

Also spotted Danai in stealth mode in the VT commodore on Port Rd

Spotted a chick in a silver 4 door 34 with bodykit while i was out washing the 34 on the front lawn. I used buckets, i swear :thumbsup:

it was actually a vx Damo...

your car looks TOUGH up close mate

some wanker last night (fri/sat) about 2am in a little hatch back came off McIntyre road on the golden way flat out, didnt look, and nearly took out a grey 33. luckly the driver of the 33 saw it coming and swerved, if your on here mate, i take me hat off to you for you quick reactions.

a dark (forgot exact colour) 33 parked at BP Golden Grove with a skylinesaustralia.com sticker on the front windscreen on sat about midday.

another dark 33 at the shell station GG with a female driver about 11.30pm

Spotted black 32 ... plates CBFED2 pulled over my the cops in the city last night. Waiting at lights ... cops pull up behind him 30 secs later ... sees the Skyline badge and lights him up.

Hope he got off okay. I was at a buck's night, so didn't wander down.

spotted a certain silver autech rs260 last night :geek: was in mates white s14 that followed you for a bit coz he wanted the check it out... he didnt know about the rs260 till last night.

looks crazy clean!! awesome buy there.

Spotted a tough as 34GTR in Bayside Blue this arvo coming down Golden Grove Rd. Also BILYBOB on Ladywood Rd

This may have been a mate of mine that lives close by, he has not long had it. Will tell him to get his butt on her and post up lol

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Per Mark Roberts of Sonictune: Mark Robert Author At this time, no. No ETA either 2016-17 models. You will be able to purchase and install a 2018.5+ TCU though   TCU purchasing and pricing info! As we near the release of TCU tuning, I am going to answer some questions I get asked often.   What do I need for TCU tuning? At this time, you will need a 2018.5+ TCU to be able to tune. If you have a 2016-to early 2018, you will need to replace your TCU with the newer version. One good way to know if your TCU is good is if you have auto upshift in manual mode in 1st gear around 6500 rpms. If your manual 1st gear goes to 7k rpm and will hit the rev limiter unless you shift, you have the older TCU.   Why do I need to buy another ecu license/phone flash if I already have it on my ECU tune? The TCU is its own computer module. It is completely separate from the ECU. Because of this, you will be required to purchase a TCU license and, if your tuner has it, the phone flash license required to tune it via phone/bluetooth.   Do I need TCU tuning? TCU tuning is NOT required. However, the faster your setup, the more it will assist in track and dragy time consistency.   If I’m ECU tuned by (tuner A) can I get my TCU tuned by (Tuner ? Yes, since it’s a different module and a completely separate flash, you can have two different tuners. However, it is highly recommend that you have both tuned by the same tuner. For me, my TCU tuning will directly complement my ECU tuning style and features and running my ECU and another TCU or vice versa MIGHT cause some issues. At this time and for the foreseeable future, I will only be tuning my current ECU tuned customers TCUs.     I have a SYVECS AWD controller. Do I still need it? Yes! The AWD controllers main job is to control your AWD system. However, with TCU tuning, you will no longer need the auto-shift function as that will be done through the TCU. The AWD controller will still be very beneficial for racers looking to maximize traction on the launch.     Shift schedule changes: holding gears longer at lower pedal input as well as max shift rpm changes. Please note, the new ECU race rom coming out will address 90% of the shitty drivability issues these cars have through custom maps from myself and Racebox—as well as others I am sure.   Increase shift speeds: as seen in the videos I’ve been posting, the TCU shifts much faster once tuned.   Increased shift pressures: as also seen in the videos, much firmer full throttle shifts.      
    • Per Mark Roberts of Sonictune:     Mark Robert Author At this time, no. No ETA either 2016-17 models. You will be able to purchase and install a 2018.5+ TCU though   TCU purchasing and pricing info! As we near the release of TCU tuning, I am going to answer some questions I get asked often.   What do I need for TCU tuning? At this time, you will need a 2018.5+ TCU to be able to tune. If you have a 2016-to early 2018, you will need to replace your TCU with the newer version. One good way to know if your TCU is good is if you have auto upshift in manual mode in 1st gear around 6500 rpms. If your manual 1st gear goes to 7k rpm and will hit the rev limiter unless you shift, you have the older TCU.   Why do I need to buy another ecu license/phone flash if I already have it on my ECU tune? The TCU is its own computer module. It is completely separate from the ECU. Because of this, you will be required to purchase a TCU license and, if your tuner has it, the phone flash license required to tune it via phone/bluetooth.   Do I need TCU tuning? TCU tuning is NOT required. However, the faster your setup, the more it will assist in track and dragy time consistency.   If I’m ECU tuned by (tuner A) can I get my TCU tuned by (Tuner ? Yes, since it’s a different module and a completely separate flash, you can have two different tuners. However, it is highly recommend that you have both tuned by the same tuner. For me, my TCU tuning will directly complement my ECU tuning style and features and running my ECU and another TCU or vice versa MIGHT cause some issues. At this time and for the foreseeable future, I will only be tuning my current ECU tuned customers TCUs.     I have a SYVECS AWD controller. Do I still need it? Yes! The AWD controllers main job is to control your AWD system. However, with TCU tuning, you will no longer need the auto-shift function as that will be done through the TCU. The AWD controller will still be very beneficial for racers looking to maximize traction on the launch.     Shift schedule changes: holding gears longer at lower pedal input as well as max shift rpm changes. Please note, the new ECU race rom coming out will address 90% of the shitty drivability issues these cars have through custom maps from myself and Racebox—as well as others I am sure.   Increase shift speeds: as seen in the videos I’ve been posting, the TCU shifts much faster once tuned.   Increased shift pressures: as also seen in the videos, much firmer full throttle shifts.      
    • The fancy pants red shock tower brace is finally incoming from MX5 Mania, getting it shipped from 'Merica has been a long and problematic process, and GWR, the 'Merican supplier will not ship directly to consumers outside of the US, Mania basically had to order a heap of them, the colour choice was silver, or red, and we all know anything red adds 5 killerwasps of dynotorques..... Whilst it does fit over a 2.5, and I've seen a few photos and videos of it being installed and fitting, google also says it might get real close to the FAB9 intake front runner, people in the US says it does fit with the FAB9 intake, except for one person who said it slightly touched.......so there is that.....LOL..... As it seems that I am the first in AU to have this combination of parts there's no local knowledge about fitment, so I'm just a willing guinea pig in this endeavour, I'll cross my fingers and toes and hope for the best In other news, I ordered stuff from China  on the same day I ordered the 23° silicone bend from Victoria, the stuff from China arrived a day ago, the 23° silicone bend is still travelling around Australia thanks to Australia Post, and "may" be here next week
    • Very good news...I contacted Racebox about it last night. My car is a 2016 so remains to be seen if it is compatible, requires a TCU swap, or is impossible.
    • What ECU are you running? This is probably the biggest question. If it's a PowerFC, I'd probably change the ECU and get something newer that will handle the injectors in a nicer way.
×
×
  • Create New...