Jump to content
SAU Community

Recommended Posts

spotted a bunch of nice cars at EX HP show

Evil 33... chick driving , grind off the muffler on entrance drain to show

chick flogging a yellow Hyundia with a body kit past the show, going at least 80k when she hit the humped up bricks in front of the show going airborne...hahaha muppet!!!

film crew doing a movie on top of south rd yesterday as I went past

commy loosing control ,backed into the guard rail yesterday am on south rd

Spotted a white stagea about 8:30am up ahead of me at the seacombe lights turning onto south road, heading south. Was in a white pulsar so no way of catching up :( was about 4-5 cars back at the lights

souds a lil bit like kev (silhouette) in his white whale daily

spotted marko in his 33 i reckon on south road this arvo. vs-xx wheels, rear overfenders. was behind ya then next to ya for a bit thru the gallipoli underpass (stuck at the works) around 2, then seen ya talkin to me mate adrian over at instant windscreens not long after :D

chick flogging a yellow Hyundia with a body kit past the show, going at least 80k when she hit the humped up bricks in front of the show going airborne...hahaha muppet!!!

Did it have a bonnet scoop? reckon i may have seen the same 1 flying past me on salisbury highway

lol

only got 14.7 litres per 100km last tank. probably cos i had the aircon going :P

hehe mileage eh....

first year and a half I owned the gtr it had a broken aircon. ended up pissing me off i removed the dash and all the centre console so I could simply get to the door mix actuator motor.... steve posted a guide and I took the unit out and got a mate to fix the dry joints - now it works a chaaaarm... damn the petrol, i'll go without that extra beer in an aussie summer

oh yeah and the drivers side aircon vent was plugged and had a 2" gauge instead. A broken gauge at that. yoink. yeah that went asap.

and anyone who buys a gtr for the mileage deserves to be lold at ;)

-D

Spotted a white stagea about 8:30am up ahead of me at the seacombe lights turning onto south road, heading south. Was in a white pulsar so no way of catching up :P was about 4-5 cars back at the lights

if it was on redwall'd 19s then it was me.

while at the gym today saw 2 stageas cruising down anzacs, green one and white one, both had rims and the rear roof duck wing things on both. Was at the lights at anzac/morphett road. Would have been about 3:30ish i think.

And a stock looking 34 4 door parked on mooringe ave, white, p plates.

white r33 with dior as the plates sau sticker on it, near work.

at work black r32 gtr with aftermarket sideskirts cc plates big intercooler with apex or something spray painted on it, naughty naughty with that handicap parking yesterday :P

Edited by Inline 6

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Per Mark Roberts of Sonictune: Mark Robert Author At this time, no. No ETA either 2016-17 models. You will be able to purchase and install a 2018.5+ TCU though   TCU purchasing and pricing info! As we near the release of TCU tuning, I am going to answer some questions I get asked often.   What do I need for TCU tuning? At this time, you will need a 2018.5+ TCU to be able to tune. If you have a 2016-to early 2018, you will need to replace your TCU with the newer version. One good way to know if your TCU is good is if you have auto upshift in manual mode in 1st gear around 6500 rpms. If your manual 1st gear goes to 7k rpm and will hit the rev limiter unless you shift, you have the older TCU.   Why do I need to buy another ecu license/phone flash if I already have it on my ECU tune? The TCU is its own computer module. It is completely separate from the ECU. Because of this, you will be required to purchase a TCU license and, if your tuner has it, the phone flash license required to tune it via phone/bluetooth.   Do I need TCU tuning? TCU tuning is NOT required. However, the faster your setup, the more it will assist in track and dragy time consistency.   If I’m ECU tuned by (tuner A) can I get my TCU tuned by (Tuner ? Yes, since it’s a different module and a completely separate flash, you can have two different tuners. However, it is highly recommend that you have both tuned by the same tuner. For me, my TCU tuning will directly complement my ECU tuning style and features and running my ECU and another TCU or vice versa MIGHT cause some issues. At this time and for the foreseeable future, I will only be tuning my current ECU tuned customers TCUs.     I have a SYVECS AWD controller. Do I still need it? Yes! The AWD controllers main job is to control your AWD system. However, with TCU tuning, you will no longer need the auto-shift function as that will be done through the TCU. The AWD controller will still be very beneficial for racers looking to maximize traction on the launch.     Shift schedule changes: holding gears longer at lower pedal input as well as max shift rpm changes. Please note, the new ECU race rom coming out will address 90% of the shitty drivability issues these cars have through custom maps from myself and Racebox—as well as others I am sure.   Increase shift speeds: as seen in the videos I’ve been posting, the TCU shifts much faster once tuned.   Increased shift pressures: as also seen in the videos, much firmer full throttle shifts.      
    • Per Mark Roberts of Sonictune:     Mark Robert Author At this time, no. No ETA either 2016-17 models. You will be able to purchase and install a 2018.5+ TCU though   TCU purchasing and pricing info! As we near the release of TCU tuning, I am going to answer some questions I get asked often.   What do I need for TCU tuning? At this time, you will need a 2018.5+ TCU to be able to tune. If you have a 2016-to early 2018, you will need to replace your TCU with the newer version. One good way to know if your TCU is good is if you have auto upshift in manual mode in 1st gear around 6500 rpms. If your manual 1st gear goes to 7k rpm and will hit the rev limiter unless you shift, you have the older TCU.   Why do I need to buy another ecu license/phone flash if I already have it on my ECU tune? The TCU is its own computer module. It is completely separate from the ECU. Because of this, you will be required to purchase a TCU license and, if your tuner has it, the phone flash license required to tune it via phone/bluetooth.   Do I need TCU tuning? TCU tuning is NOT required. However, the faster your setup, the more it will assist in track and dragy time consistency.   If I’m ECU tuned by (tuner A) can I get my TCU tuned by (Tuner ? Yes, since it’s a different module and a completely separate flash, you can have two different tuners. However, it is highly recommend that you have both tuned by the same tuner. For me, my TCU tuning will directly complement my ECU tuning style and features and running my ECU and another TCU or vice versa MIGHT cause some issues. At this time and for the foreseeable future, I will only be tuning my current ECU tuned customers TCUs.     I have a SYVECS AWD controller. Do I still need it? Yes! The AWD controllers main job is to control your AWD system. However, with TCU tuning, you will no longer need the auto-shift function as that will be done through the TCU. The AWD controller will still be very beneficial for racers looking to maximize traction on the launch.     Shift schedule changes: holding gears longer at lower pedal input as well as max shift rpm changes. Please note, the new ECU race rom coming out will address 90% of the shitty drivability issues these cars have through custom maps from myself and Racebox—as well as others I am sure.   Increase shift speeds: as seen in the videos I’ve been posting, the TCU shifts much faster once tuned.   Increased shift pressures: as also seen in the videos, much firmer full throttle shifts.      
    • The fancy pants red shock tower brace is finally incoming from MX5 Mania, getting it shipped from 'Merica has been a long and problematic process, and GWR, the 'Merican supplier will not ship directly to consumers outside of the US, Mania basically had to order a heap of them, the colour choice was silver, or red, and we all know anything red adds 5 killerwasps of dynotorques..... Whilst it does fit over a 2.5, and I've seen a few photos and videos of it being installed and fitting, google also says it might get real close to the FAB9 intake front runner, people in the US says it does fit with the FAB9 intake, except for one person who said it slightly touched.......so there is that.....LOL..... As it seems that I am the first in AU to have this combination of parts there's no local knowledge about fitment, so I'm just a willing guinea pig in this endeavour, I'll cross my fingers and toes and hope for the best In other news, I ordered stuff from China  on the same day I ordered the 23° silicone bend from Victoria, the stuff from China arrived a day ago, the 23° silicone bend is still travelling around Australia thanks to Australia Post, and "may" be here next week
    • Very good news...I contacted Racebox about it last night. My car is a 2016 so remains to be seen if it is compatible, requires a TCU swap, or is impossible.
    • What ECU are you running? This is probably the biggest question. If it's a PowerFC, I'd probably change the ECU and get something newer that will handle the injectors in a nicer way.
×
×
  • Create New...