Jump to content
SAU Community

Recommended Posts

You didn't have to pull those 4 bolts out, you just need to remove the cir-clip holding the shifter in at the bottom where it pivots, and she will slide right out.

I dunno where you got the idea from but whats wrong with filling it from the fill plug on the gear box? If you can get your hands on a little hydraulic pump just shove it in the new oil bottle and pump away until she is full.

Hope you know how much oil to put in, goodluck. :worship:

either spend $20 on the little pump bottle or $20 on a pair of circlip pliers. I like doing it from the top. It's clean and easy. You always end up with half an arm covered in gear oil if you do it from under the car

+1 for filling through the shifter hole.

I use a pair of needle nose plyers with the points bent inwards as circlip plyars for all nissans boxes... its lasted me 5 years so far and counting :worship:

provided you know exactly how much to fill the box. you cant go wrong!

I haven't had a good enough look at my GTR but why does the stick go into the transfer case and not the gearbox? Doesn't the transfer case literally transfer drive to the front wheels? From what I can see the transfer case hangs off the driver's side of the gearbox and the stick is perfectly above the gearbox itself like any other rwd car. Just wondering the reasoning?

Cheers,

Matt

i hope you have a 2wd. in 4wd the gear stick goes into the transfer case not gearbox

hey you don't have to beleive me but maybe you should take a closer look. the gear stick goes into the xfer case and actuates the gearbox via a linkage. the transfer case is bolted to the back not the side of the gearbox

hey you don't have to beleive me but maybe you should take a closer look. the gear stick goes into the xfer case and actuates the gearbox via a linkage. the transfer case is bolted to the back not the side of the gearbox

^believe this guy, trust me, i found out the hard way.

Sorry didn't mean to be rude, but cool thanks for that. Was just wondering the mechanics of it all, this is the same for all GTRs? Also, does that mean you can fill the transfer case from the stick?

hey you don't have to beleive me but maybe you should take a closer look. the gear stick goes into the xfer case and actuates the gearbox via a linkage. the transfer case is bolted to the back not the side of the gearbox

sorry its been a long week. the xfer case bolts onto the rear of the gearbox, and yes you can fill the xfer case through the shifter on a 4wd. bascially the xfer case has a main shaft to the rear wheels and another for the fromt shaft linked by a big chain.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • And I just realised that that advice is slightly nonsensical for a GTR, because you need 2 of them. But it is otherwise true.
    • Having had a reasonable look at the car, I'll be able to remove the (one time) rams and retract the hinge (they are held in the down location by a tiny (m3?) sacrificial screw) which will get it physically back in shape. From there if you remove the rams you need a resistor to turn off the airbag light (as Mark said, there are plug in kits and I might go that way because its reversible). And...per all the threads on here, even if you have the resistors to turn off the airbag light, the bonnet light will stay on as it writes to the airbag computer history - that is either replace the airbag controller, reprogam the EPROM (if I can work out how), or remove the globe from the dash. Having seen how sensitive this system is, if I had my time over I'd pre-emptively remove the rams, even on a road car, because this is all a very unnecessary pain in the arse. Reminds me, time to go and have a look at the Fuga too....
    • Hi, I need same this wing nismo , Does anyone have one for sale?  if any one have can contact me  00966546888343
    • Nah, lots of insurance repairs on V36 and V37 for pedestrians deployments. Reasons ranging from possums, to extremely severe potholes have deployed them. However, paying for the full repair can still be upto $5k AU some people have noted!
    • Hi, i got 1998 r34 4 door auto abs model and its manual converted with bigbox when i bought it . I successfully find the neutral and reverse light wire but can’t find the speed signal wires for speedo drive. I know its grey plug but on my loom no grey plug with 2 wires . I opened the loom upto where it getting branch with other wire, i’m amazed they is no wire. So need help how to fix the speedometer problem. I search on google it says some r34 model measure speed from diff sensor. Is it right? I talk to a wrecker he say no this isn’t right, i’m kinda stuck. Please help
×
×
  • Create New...