Jump to content
SAU Community

Recommended Posts

Hey guys i recently stuck my car in to get tuned, they reached about 9 psi and started to have issues with knockin.. etc scratched their heads for a while and worked out that the air fuel ratio was changing dramatically between runs without them changing any settings.. between high 10:1's to low 12:1's on boost

my mods are intank walbro fuel pump, power fc, fmic, full exhaust n a blitz ebc.. ive tried earthing the fuel pumps earth to the battery and the results remained much the same

any ideas would be greatly appreciated

Cheers

Jarrod

Link to comment
https://www.sau.com.au/forums/topic/217183-varying-afrs-on-dyno/
Share on other sites

yeh i would of liked them to have done this but i wasnt there as i was at work, had a mate take it up.. the ppl that dynod it turned out to be completely useless coz they could of chekd the coilpaks n pressures while it was on a dyno, n i don't want to have to send it to another place n another dyno just to get the problem resolved, just would like to know some of the most likely causes.. the earth wire on the in tank fuel pump is exposed n a little corroded.. that couldnt be causing the issue could it?!!

located in perth guilt-toy, thanks for the pointers guys ill probally replace the fpr first and over the fuel pump becuz its the cheaper one to replace... are they any fpr's that are direct replacement that dont need adjusting? is the sard one any good?

located in perth guilt-toy, thanks for the pointers guys ill probally replace the fpr first and over the fuel pump becuz its the cheaper one to replace... are they any fpr's that are direct replacement that dont need adjusting? is the sard one any good?

It goes in this order

Test

If broken

Replace

Dont just go replacing random parts dude, test them, find the problem and then fix it the first time rather than bringing more problems into the equation

you said it was doing it under load, you must therefore test it in the same fashion

You 'can' do it on the street, but you wont be able to see the AFR's without a wideband and a proper read out.

Take it back to the dyno place and demand they do a semi-reasonable job. They did a half assed one last time

yeh i got a wideband with a datalogit.. i rang up the shop this morning n askd why they didnt test the fuel pressure n they claimed coz they were borrowin the dyno they didnt have their tools with them to do it ... so now i have the dilemma of sendin it to another shop with a dyno to diagnose.. why im tryin to just fix it myself coz all the shops in perth seem to be useless..

anyone know if a 180sx fuel pump will work in a r33 gts-t?!? i borrowed a girl my stock one because she thought her one was broken n claimed several ppl said it was the fuel pump so after we installed the fuel pump for her we found out she had a kink in her fuel line, when and got home, i tested her fuel pump n it still worked.. id swap them back sooner but shes in bali for a while .. so would it be fine to test a 180sx one in the skyline for a run to see if the afr's hold more steady on the wideband

ahh think i might just buy the new fuel pump.. standard wiring isnt the best anyway the earth wire is exposed and a little corroded so ill buy a full replacement one... so tomei or nismo?!! i know you probally can't go wrong with either but what one would allow for more hp?

Cheers for all the advice aswell guys

  • 2 weeks later...

hey guys sorry to bring up an old thread but im still having afr troubles, i bought a new tomei fuel pump to replace the walbro, no change still playing up... bought a sard adjustable fuel pressure regulator.. same results...varies between 12 n 14.4 around the 6psi mark... and varies between 9.5 and 12.2 around the 10 psi mark... im measuring the results with a innovative motorsports lc-1 hooked upto a lap top... has anyone else got any other ideas that could cause the results to vary so much

Cheers

Jarrod

Edited by jarrod83

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
    • I've managed to find this: Nissan_Stagea_AutechVersion260RS (1).pdf
×
×
  • Create New...