Jump to content
SAU Community

Recommended Posts

This photo must have been taken after I left cos I spent most of the day standing next to this with my jaw on the grass :D

when I was a kid you couldn't give those away. in USA trim.. but retro is back

premo condition too

thought it was about time to put up a photo of a couple of my other "secretive" rides :P

one has a 285hp 6 cylinder, big turbo, lotsa noisy spool. pulls like a truck :rofl:

the other is also a turbo 6, loves being held flat stick, and has good handling skills :rofl: :rofl:

DSCN0239.jpg

note: we do let rangas drive loaders :laugh:

Yeah I was checking out Seb's GTR at Willall's the other week - that front bar is a true work of art, and the photos just don't do it justice. Even the bonnet is a serious bit of kit. The whole car is so droolworthy it hurts! Oh, and it goes ok too - the G forces are enough to burst your kidneys when going around a corner :D:ninja:

Oh, and for those that don't FB or check the spotted thread, here is a pic of a new beast addition to the SAU family :D - it doesn't go half bad either :) And it has the wife and 11 week old's approval :D

post-669-0-63359000-1306840632_thumb.jpg

post-669-0-02529100-1306840650_thumb.jpg

post-669-0-94566900-1306840659_thumb.jpg

post-669-0-56054300-1306840672_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...