Jump to content
SAU Community

Recommended Posts

  • 3 weeks later...

Oh the old 510 , check out adam carolla in usa he has some of the bob sharp 510's and races vintage in california

I had a 1200 coupe ( half dozen of them over the years) but wanted a 2 dr 510 so bad , they all ended up as race cars lol

Spotted a nanna spec rolla the other day i wanted to follow her home to buy it haha 2 dr even bet it had less then 10,000km on it perfect nick

as always josh, looks tops

cant wait to see it in action up the Mile

heres mine, causing some controversy now with my new rims :P

cage is nearly done (just needs the rear section notched and welded in), boot floor being prepped for fuel cell + fuel pumps, motor is about a week off being ready (tops), then its put it all back together and wire in the Haltech

425863_2976702648871_1000982751_32668484_278229451_n.jpg

424861_2976701248836_1000982751_32668483_457962819_n.jpg

Gonna make it to alma matty ?

Yeah, we'll be fine. Once everything gets back its a matter of putting it all together. Saving the week leading up to Mt Alma to be doing last minute fixes and the tune

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Admittedly in that screenshot its doing about 13psi but later on in the log theres definitely spikes to 16. What is missing though is the massive peak, then a big drop and then a recovery. While it does go a little higher than I would like on base pressure, I think it's reasonably safe to assume that boost control via the mac valve should be a lot easier to control from here on out. I wasn't game to hook up the mac valve today as it's very wet and it's on the verge of fighting traction as it is.
    • I think this is still wrong. There is something crappy with wastegate priority (or the f**king absence of it) if you can't get below nearly double the base spring pressure. But if you're happy with what you've got, upload skid vids now.
    • So a further update for this one. Turbosmart were very gracious and took one look at the wastegate and said this is our original version, we will just replace the entire thing and send it back to you. So I fitted the new wastegate with its new revisions and took it around the block on spring pressure (9 psi spring). Appears the minimum it will do is about 16psi. Keep in mind this is only 2nd and 3rd gear pulls. I think the issue is fixed compared to what it was doing before however I'm happy to provide more logs if anyone thinks theres more to the story to uncover
    • Surely, if you have the indicator in hand and a pair of verniers, you can measure it up and draw your own cut template? I mean, it's got to pretty clear what has to pass through the hole, what has to sit on the outside face of the hole, and what has to be able to pass through and perhaps clip into place on the back side.
    • Man, I hope this one gets finished  i just randomly remembered it the other day and thought I’d check in. 
×
×
  • Create New...