Jump to content
SAU Community

Recommended Posts

Hey ppl.. just trying to figure out what ecu to go for.. at the moment i have a stock ecu in my 93 R32 GTR and have just finished off rebuilding my motor from top to bottom and it has now received the following:

- Stock bottom end

- N1 oil pump

- Garrett GT2860 - 10 turbochargers

- Tomei Type A camshafts 260 degree 9.15mm lift

- 550cc denso injectors

- Higher volume fuel pump

- Larger FMIC

Not sure what figures i should be expecting, hopefully someone else out there with a similar setup can tell me what numbers they a pulling at all fours and also advise on what management system i should perhaps go for, which is easy to use and run... Thanks :P

re-map it.. who can do that, i mean, to put a power fc its going to cost roughly $1800 including install and the tune.. is it worth it?

by remaping, what can you gain from this and how much is it usually?

few diffenrent paths which you could go down, however, bang for buck??

hearing great stuff on the Vipec ecu, mixed emotions on power fc and wolf... but when it comes down to how much and what you have paid for which is the better option??

right now, i am leaning towards a power fc and only reason is because they have been around for that long and everyone is using it, and that i hear more people going from one ecu to power fc and hardly people going from power fc to somehting else......

hmmm food for thought! :O

few diffenrent paths which you could go down, however, bang for buck??

hearing great stuff on the Vipec ecu, mixed emotions on power fc and wolf... but when it comes down to how much and what you have paid for which is the better option??

right now, i am leaning towards a power fc and only reason is because they have been around for that long and everyone is using it, and that i hear more people going from one ecu to power fc and hardly people going from power fc to somehting else......

hmmm food for thought! :O

Well i had a power fc before and went to the Vipec system as did a few of my friends and they all recommend it.

Got rid of my afm's and gain power all across the rev range with the Vipec, aswell as much smoother idle etc. my other car has a Haltech e11v2 and the Vipec is on par. And for $1600, why wouldnt you??

Go for the Vipec ecu. I just got one and can't be happier with the results :banana:

I will have to agree here too. If you got the pennies go the V88 and hook into the factory knock sensors.

purchase, install and tune power fc.... roughly looking at $1500

purchase, install and tune vipec... roughly $1600.... but like what most people have said, some instances have seen an extra 30awkw's from coming from a power fc tune to a vipec tune...

for an extra $100 odd that seems to be pretty good! thanks guys helped me heaps, muchly appreciated.. let u know how it goes!

Wolf - local manufacture, local (24/7) support.

It will set you back around $2500, installed and tuned. In that, they keep the car for a week to get the cold starts working correctly as well.

The results you will get are only as good as the tuner. So, no matter which ECU you choose, get it tuned by someone who knows the unit. All Wolf tuners (as listed on their website) are trained by Wolf.

lets just clear this up, it shouldnt matter if you use a motec, a powerfc, a ninetendo gameboy, a hks fcon pro, an iphone, or the latest vipec

the power output should be the same, the response, torque etc should all be the same if and only IF

they are tuned correctly

so for the people who move from ecu ABC and then install ecu XYZ and gain power

my first response is the original ecu wasnt tuned properly or not setup properly

furthermore i cannot see how there would be a power gain moving from afm sensor to map sensor

Well i had a power fc before and went to the Vipec system as did a few of my friends and they all recommend it.

Got rid of my afm's and gain power all across the rev range with the Vipec, aswell as much smoother idle etc. my other car has a Haltech e11v2 and the Vipec is on par. And for $1600, why wouldnt you??

Without starting another ECU war or whatever else.

Whoever you were using to setup the PFC, didnt do the job correctly, there is nothing more to that.

lets just clear this up, it shouldnt matter if you use a motec, a powerfc, a ninetendo gameboy, a hks fcon pro, an iphone, or the latest vipec

the power output should be the same, the response, torque etc should all be the same if and only IF

they are tuned correctly

so for the people who move from ecu ABC and then install ecu XYZ and gain power

my first response is the original ecu wasnt tuned properly or not setup properly

furthermore i cannot see how there would be a power gain moving from afm sensor to map sensor

Exactly.

My RB26, PFC idles fine, drives fine and makes the same power/response as any other RB26 with the same setup.

Id imagine it would be the same regardless of my ECU choice for that matter as long as the person setting it up, knows what they are doing

badgtr - end of the day its like this.

1. Pick your tuner

2. Use the ECU they are most comfy with.

3. Make sure that ECU at least is semi-common so if you have an issue later, you can switch tuner without much issue

Simple as that.

Every ECU for a STREET CAR is just as good as any other. Its all about it being setup correctly.

Having launch control, 15 auxilary inputs, anti-lag or any other thing that sounds good but in reality you'll never use, is just pointless and shouldnt be something you consider when buying the ECU for a STREET CAR

furthermore i cannot see how there would be a power gain moving from afm sensor to map sensor

Unless the engine is consuming enough air that the AFM are causing a restriction. Otherwise I agree.

Cheers

Marty

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I couldn't agree more. I should have started from the get-go with a NEO or solid bucket conversion. I started looking into converting over to solid lifters yesterday. Now for some reason I was always under the impression that when using the Tomei solid lifter conversion, you would also require new valves (Longer or shorter stems, I can't remember which).  But I see no mention of this on any of the Tomei documentation. It just states I need the Tomei solid buckets, solid lifter cams and upgraded springs. As my head is already built, all I would need is another set of 1000$ Kelford cams, 500$ buckets and about 4H hours of my time installing and I'm off to the races!?!? There's no way it's that simple, I must me missing something? 
    • BRUH, one of the biggest mistakes of my life..... and i've had plenty ;[)
    • @Murray_Calavera iam just considering options 🙂 of course it is very expensive so that why i ask here 🙂  @joshuaho96 I looked at that GCG hybrid(i remember looking at it few weeks before) So this is "that" hybrid where i send them my turbo and they upgrade the inside to Garrett stuff and then they send it back. It cost around 1200-1300 USD which is FAR cheaper than the HKS and it is what iam looking for(i just do not have experience like this...to send something off to "upgrade" ) @tylink720 that is like 150 USD turbo no? 😄 I dont think i have the "ease on my mind" with this kind of turbo. I just put over 7000k USD to "LINK" up my engine...dont want to blow it up with cheap turbo 😄     EDIT: https://www.cj-motor.com/gcg-turbo-charger-for-nissan-rb20det-rb25det-high?srsltid=AfmBOooVeOZ6CZ6r1AIv5m-KPaa6BvudIPJTY8LW78khkd-gQlsaCht9 I looked at this and it seems ok? It is that CGC hybrid and it costs around 1250 USD (with back shipping). Do any of you have experience with this hybrid on NEO turbo? I quickly look thru the forum/web and it seems very good.
    • Echo the awesome sentiment 👍 Definitely a car worth saving. Looking forward to seeing updates as well. 
    • Scenic roads, stunning skylines, and Chickos to finish it off! Join SAU NSW as we cruise through the Royal National Park and along Lawrence Hargrave Drive to Figtree! Sunday 26th October 2025 4:30PM Meeting Waterfall Station Parking 5:00PM Cruise Departure Royal National Park > Lawrence Hargrave Dr > Memorial Dr > Sid Parrish Park 6:15PM Arrival at Sid Parrish Park Figtree Meet Location: Waterfall Station Parking Final Destination: Sid Parrish Park RSVP: https://forms.gle/E4s5SiRKQfDdypky8 *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...