Jump to content
SAU Community

Recommended Posts

Hooray. Ive finally worked it out.

You know the beep that happens when youre trying to work on your pride and joy and listen to some music with the door open and all you can hear is the "beep beep beep".

Well I found the control box to fix it

You have 2 options to fix this.

1. Get a ridiculously loud sound system, and annoy the neighbours...

or 2. Cut a wire.

I went for option 2 because I like my neighbours.

Located under the dash on the drivers side is a little black box labelled "smart entrance".

There is a black wire with a purple stripe on it. Cut it and wrap electrical tape over the ends.

Thats it.

This does not mean that when you leave your lights on you wont get that beep, you still will.

Thanks to Jack88 for informing me of the colour of the wire. :)

This is my first DIY so I hope it is helpful and not pathetic!!

Cheers, Jase. :bunny:

post-39053-1221710609_thumb.jpg

post-39053-1221710628_thumb.jpg

post-39053-1221710651_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/236588-how-to-stop-the-door-open-beep/
Share on other sites

As my car is in a million pieces while it is getting repaired I decided to go looking for the wire you mention. I also couldn't find it.

So I went for option three which was to take that plastic strip off the door and disconnect the sensor at the door end. Took about 2 minutes.

The downside is that the interior light doesn't come on when the doors are opened, but that doesn't really bother me as much as that beeping did...

As my car is in a million pieces while it is getting repaired I decided to go looking for the wire you mention. I also couldn't find it.

So I went for option three which was to take that plastic strip off the door and disconnect the sensor at the door end. Took about 2 minutes.

The downside is that the interior light doesn't come on when the doors are opened, but that doesn't really bother me as much as that beeping did...

lol, by doing that, (and if you have an a alarm also) it will disable the alarm as its wired to the switch.

lol, by doing that, (and if you have an a alarm also) it will disable the alarm as its wired to the switch.

No alarm so no worries for me :)

Sure its not a perfect system but it worked for me...

or you could just turn the car to the ON position when working on your car and beeping gone? lol no cutting of wires required.

ahhh, no. sometimes i work on my car for hours. bye bye batttery and isnt that bad for the ignition system??

i should also add that in a series 1 its to the left hand side of the glove box housing,not in the same place as the series 2's. check my tut for the series 1 version.

Edited by Jack88

hey all

found another way to get rid of the beep without cutting the wire.

i simply listened to where the beep was coming from and unplugged the plug that went to the lil siren.

heres a video of mine. btw its a s1 r33 gtst.

http://www.youtube.com/watch?v=no0mmj9DCns

hope this helps those that couldnt find the wire.

if you cant be bothered watching the video, its a lil orangy yellow box just on the left hand side of the steering column. it has a white plug with wires facing down.

Jaye

Edited by auss13

was installing the alarm on the gtr and there are two plugs one for the door beep and one for the lights,on the back of the key barrel.means you have to pull apart the trim around the steering column. just unplug that and should all be sweet. no cutting of wires. (don't ask me what colour or anything as my dad did it who was an auto elec for a while).

hey just did mine, different way though.

entry is via the small pull out section near bonnet release.

on the right hand side, under the steering wheel is a black box with 'smart entry' on it, size is about 4cm by 7cm

undo 2 screws to take the box off the holding bracket.

take out white plastic plug from box. (sticks in there pretty good)

the black surround around where the plug went comes out, you will see where u can put in a screwdriver to jimmy it out.

take out the circuit board.

match up where the actual beeper is from where the audio holes are on the side (it is a round black cylinder abour 5c piece in diamater and 10 cm high)

CAREFULLY either:

1- prize it off with a flathead screwdriver and pull out the terminals with some needle nose pliers gently (i did it this way easily)

2- get a solder iron and reheat/undo the conection from the back

put everything back the way you found it :)

this way it wont phuk with you alarm or windows or anything else, cos everything is as it was, just no noise cos obviously no beeper :(

btw car was a r33gtst S2, should take about 20 mins max, have fun

LOL..to all these people that followed all these steps..

Easier choice, unplug the loom that goes to the beeper.

It's right under the steering column guys...listen and you will find a small black plastic box bout the size of a match box with a little hole in it where the beeping comes out of.

Everything still works fine..ie Alarm, windows..bla bla bla...

It's just the loom that sends a signal to the beeper to well literally beep and annoy the sh*t out of you.

LOL..to all these people that followed all these steps..

Easier choice, unplug the loom that goes to the beeper.

It's right under the steering column guys...listen and you will find a small black plastic box bout the size of a match box with a little hole in it where the beeping comes out of.

Everything still works fine..ie Alarm, windows..bla bla bla...

It's just the loom that sends a signal to the beeper to well literally beep and annoy the sh*t out of you.

Yep. I thought that was what people meant when they unplugged the beeper itself?!?!

Why you'd mess with anything else is beyond me.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well, I can recommend the partial AV system translation CD I ordered from Car Audio Workshop in NZ. Whilst it didn't address the date issue, it has conveniently translated on-screen menu items into English, and now allows the GPS-received time to be offset in hours rather than minutes, so I can display Eastern Australian time accurately ( and bump it by another hour when daylight savings starts ).
    • Yuh, if it's 45°C outside, my car is driving in it.
    • I'd be curious to hear more. Otherwise, have you driven a modern x-trail? I wonder how it compares. Here in Australia they are/were popular for rentals and fleet vehicles. I have been in some and my impression was they are bad. But, this may have been very different in the 2000s at a good trim level. Twenty years is plenty of time to make the model worse. I do very much agree with the 2 silver cars in the garage approach. But, not driving because it's too hot would not leave a lot of time in the year for many Australians. I don't think you need to worry too much unless the car has actual issues with overheating. 
    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
×
×
  • Create New...