Jump to content
SAU Community

Recommended Posts

and I was on the way up to the petrol station. was on the road, going 50km/h, braked down to 30, entered roundabout, got halfway through, let go of accelerator, turned to go around and started to lose the back end, corrected twice and was back on the road. OMG HEARTATTACK.

apart from my driving errors, what should i look at to fix the traction problems? tyres obviously, hicas maybe? the thing should be serviced anyway at this point.

auto r34 gt

Link to comment
https://www.sau.com.au/forums/topic/265312-so-it-rained-today/
Share on other sites

  • Replies 70
  • Created
  • Last Reply

Top Posters In This Topic

I have that happen in my R31, my R32 and my '85 Corolla. Its due to things that are more likely to make ur car drift.

Hard suspension is more likely to cause ur car to slide in the wet. Narrow or old brittle tyres will cause it to slip. Going into a round about to quick is enough, coz a quick left-right turn can cause it to slide. If the LSD is too tight it might lock too quick, and drift.

Be very careful in the wet dude. Its a death trap in the wet...

Yeah, was out driving in my R32 today. On paper, I should have been fine, billsteins, falkens, 4wd.

BUT even accelerating from stationary going right at about 30kmh i was getting all 4 wheels sliding... Greasy road's are deadly =\

Edited by Ten Four

when it hasn't rain in ages there is alot of oil built up on the road. so the road condition are generally poor.

It's not a traction problem, its driver error. Watch out for weight shifting, compression lock etc

everything is fine with your car

Edited by [Michael]

lift off over steer, top gear style lolz.

Tyre condition?

Fully sik spring rates?

I love the wet in the R...not too much correction required until...:) Got to watch the greasy roads in Perth, as Michael said we get a lot of oil build up

be careful overtaking in auto as well. when mine was auto i went to overtake a bus in the wet and it kicked back on me and you recon you had a heart attack. sideways pass a bus on the opposite side of the road = not good :)

nothing wrong with the car but driver error and if you can't correct that it's time to sell and buy a treddly

yep,

i've got a 31 with plenty of power, went for a bit of a drive today and had absolutely no issues with traction as i drove within the limits of myself, my car, and the roads.

Might pay to invest in a performance driving course at AHG. Just helps to get to know your car better and how to handle it in situations like these.

Could of just come on boost at an inconvienent time or there might of been oil on the road.

wOW! Someone dosent like traction :)

r34 are heavy the back end will come out no matter what in the wet just need to be careful

if it's heavy in the rear as you say it is harder to come out less weight makes the rear come out easy

Could of just come on boost at an inconvienent time or there might of been oil on the road.

My GQ wagon did same for first rain in a long time . 3rd gear doing 20ks and 1500rpm on roundabout n it kicks out ..first rains alway slippery shit i even came off my pushbike at lights yrs ago . Thank the oil n diesel leaking shit boxs of the world :D

Western Australian roads in the rain are dodgy as! I took my 33 out in the rain for the 1st time yesterday and it"ll kick out in 4th under boost in the rain! (with 275/30/19s!)

made the trip back from margaret river interesting haha.

anyway yea probably pay to take it easy in the rain till you build confidence. noone was born a good driver bro it just takes time behind the wheel :D

Western Australian roads in the rain are dodgy as! I took my 33 out in the rain for the 1st time yesterday and it"ll kick out in 4th under boost in the rain! (with 275/30/19s!)

made the trip back from margaret river interesting haha.

anyway yea probably pay to take it easy in the rain till you build confidence. noone was born a good driver bro it just takes time behind the wheel ;)

Seriously if you think that getting sideways in fourth on a wet road is testament to you driving ability you need to think again.

:D

Things to avoid are:

1. Driving like a dickhead.

2. Bragging about it on an internet forum.

This thread has made me see why people hate us in skylines... come on guys use common sense.

If your at the front of the lights there will be oil in the wheel lines (road indented).

try this:

1. move the car to the left or right of the lane to get off the oil.

2. park back a little from the lights so not to be right in it for your back tyres.

3. just nudge the car until the back wheels pass the white line and then give some gas.

o and obvious one is get better tyres or a problem i see a lot get your camber fixed so your whole tyre has contact with the road.

This thread has made me see why people hate us in skylines... come on guys use common sense.

If your at the front of the lights there will be oil in the wheel lines (road indented).

try this:

1. move the car to the left or right of the lane to get off the oil.

2. park back a little from the lights so not to be right in it for your back tyres.

3. just nudge the car until the back wheels pass the white line and then give some gas.

o and obvious one is get better tyres or a problem i see a lot get your camber fixed so your whole tyre has contact with the road.

LOL park back from lights :D

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...