Jump to content
SAU Community

Recommended Posts

anyone know what could cause this??. The 4wd light comes on, then goes off as normal.

I was at a drag race and people told me that only the rears were spinning. This explains my awful launches and slow 1/4 mile times.. the track was untreated and I was using much too hard yokohama advan slicks. Got a 13.001 @186kmh and my girl is really capable of more than that...I was about the only person not using mk drag slicks...

Link to comment
https://www.sau.com.au/forums/topic/270426-gtr-drive-problems/
Share on other sites

Open your boot, take off the bit on the driver's side and check your ATTESSA fluid level

just checked it...the levels fine(a bit high), spun the wheels and the torque gauge shows power to the front.....my assistant said the fronts did nothing

Just because wheels don't spin doesn't mean you have a problem. If anything, the fact that the rears break traction is the problem.

Go and read through any of the hundreds of threads that explain how the ATTESSA 4WD system works. Then decide if you actually have a problem.

Just because wheels don't spin doesn't mean you have a problem. If anything, the fact that the rears break traction is the problem.

Go and read through any of the hundreds of threads that explain how the ATTESSA 4WD system works. Then decide if you actually have a problem.

I know how it works...my other gtr works a treat...this one doesn't...

it could be so many things. search for attesa diagnostics either google or in the forum and run the diagnostic sequence then check the diagnostic light flashes to see if any fault codes come up. if they do follow up whatever they indicate is not working. if nothing comes up check the basics first. do you have the same sized tyres all round? are all the wheel speed (ABS) sensors intact? they can be easily damaged as they are quite exposed. you've already checked the fluid level. can you hear the pump prime when the car is turned on? go to a workshop and get them to put a pressure gauge on the pump. good workshops will know how to test the awd and know what type of pressure the pump should be outputting under certain conditions.

anyway, start by checking for fault codes.

it could be so many things. search for attesa diagnostics either google or in the forum and run the diagnostic sequence then check the diagnostic light flashes to see if any fault codes come up. if they do follow up whatever they indicate is not working. if nothing comes up check the basics first. do you have the same sized tyres all round? are all the wheel speed (ABS) sensors intact? they can be easily damaged as they are quite exposed. you've already checked the fluid level. can you hear the pump prime when the car is turned on? go to a workshop and get them to put a pressure gauge on the pump. good workshops will know how to test the awd and know what type of pressure the pump should be outputting under certain conditions.

anyway, start by checking for fault codes.

no fault codes...no nasty noises...pump runs..4wd light goes out...fluid level good....

it has uprated lsd's, and whoever wired the rear fog light managed to somehow give the brake light permanent live...so the brake lights come on when the ignition is off and if you turn the ignition on to listen to the stereo...you get that bloody awful buzzer all the time...

maybe they have tapped into something they shouldn'e have !

no fault codes...no nasty noises...pump runs..4wd light goes out...fluid level good....

it has uprated lsd's, and whoever wired the rear fog light managed to somehow give the brake light permanent live...so the brake lights come on when the ignition is off and if you turn the ignition on to listen to the stereo...you get that bloody awful buzzer all the time...

maybe they have tapped into something they shouldn'e have !

emailed the people who tuned it and dyno'd it before I owned it..they only have a 2 wheel drive dyno and said they think they either remove the abs fuse...or disconnect one of the front wheel speed sensors....

now my car does have very very heavy steering, but I put this down to a dodgy speedo conversion when it was brought over from japan...

emailed the people who tuned it and dyno'd it before I owned it..they only have a 2 wheel drive dyno and said they think they either remove the abs fuse...or disconnect one of the front wheel speed sensors....

now my car does have very very heavy steering, but I put this down to a dodgy speedo conversion when it was brought over from japan...

Heavy steering? Dodgy speedo conversion?

Japan is in km/h, what has it been converted to?

Heavy steering may indicate the HICAS computer has been disconnected, but that is the 4 wheel steering system, not sure which models get the heavy steering, I know the R33 does...

Heavy steering? Dodgy speedo conversion?

Japan is in km/h, what has it been converted to?

Heavy steering may indicate the HICAS computer has been disconnected, but that is the 4 wheel steering system, not sure which models get the heavy steering, I know the R33 does...

unclipped the connector by the bonnet release.... turn on ignition and attessa pump runs constantly...reconnect.turn on ignition and nothing....should it prime when the ignition is switched on ????? is it usually so quiet you can't hear it..but can only feel the vibration?

Heavy steering? Dodgy speedo conversion?

Japan is in km/h, what has it been converted to?

Heavy steering may indicate the HICAS computer has been disconnected, but that is the 4 wheel steering system, not sure which models get the heavy steering, I know the R33 does...

it's been converted to mph....not sure how it was converted but the car has a full cage so think getting the clocks out might be a problem??

just lifted all 4 wheels, the fronts spin when in gear but you can stop them with your foot.

I disconnected the clip under the dash and this did not cause the pump to run constantly...... which relay is it that controls the attessa pump...the blue or the black???

Am i correct in thinking the pump should be on constantly when the clips disconnected..???

just bled the system, still no power to fronts....they can be stopped with your foot !!... tried to spinning the rears but the fronts still didn't perform... no error codes.....pump seems to work fine.....levels good......what it is?? pleasse somebody......

+1 rooted clutches in transfer case. They pulled the fuse before putting it on a 2wd dyno without bleeding pressure off to the transfer case (or mech. disconnecting it). Difference in steering may be because they didnt plug the speed sensor back in, Hicas uses it.

just lifted all 4 wheels, the fronts spin when in gear but you can stop them with your foot.

If the fronts are spinning under these conditions, then my opinion is that the ATTESSA is working. What does the torque-split gauge say?

AFAIK, the front diff is open, so it would be possible to stop one side, and the other side would continue to be driven. Is that what happens?

If you remove the fuse (in a R33), the car goes to limp mode (I believe) - that makes it impossible to run it on a 2WD dyno.

Just torque transfer by fluid coupling in the transfer case can produce the same effect.

I would suggest checking the pump again, and seeing if the pressure you are getting out is correct, not just hearing a noise.. R32 manual states between 294 and 490kPa (43-71psi).

If you are getting the correct pressure and still no drive, then clutch pack..

Just torque transfer by fluid coupling in the transfer case can produce the same effect.

I would suggest checking the pump again, and seeing if the pressure you are getting out is correct, not just hearing a noise.. R32 manual states between 294 and 490kPa (43-71psi).

If you are getting the correct pressure and still no drive, then clutch pack..

The bleed nipple under the pump....turned on the ignition.....about 10ml came out...then no more.... the pump did not run constantly..as I thought it was supposed to with the bleed connector disconnected..should this bleed fast, slow or should I not have done it?

When you turn the ignition on and off the actuator thing clunks and sometimes the pump comes on...not often though..

When I bled my system, you would turn on the ignition, and there would be a slight delay and the liquid starts coming out, it wasn't that slow but it took a while to get through the tank in the back of the boot.

I turned the ignition on and off at least 5 times to make sure I gave the pump a break, there's a tutorial on this somewhere.

The fact that its not pumping doesn't sound right...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...