Jump to content
SAU Community

Recommended Posts

Euro mate said both the Toerag and the Howdy were good tow cars, his opinion on maintenance etc is based on his own experience, he runs a euro workshop in Sydeney. I asked him about the little VW diesel SUV, whatever it's called, for towing but it's too light. And probably too fragile.

Have driven a Santa Fe, not bad if you don't mind the FWD bias. My searching for 'what tow car' is over, will post once the buy is done :)

Fathom said his was a water pump failure. Apparently ALL of them required replacement, but VAG gambled. Rather than issueing a recall that was unmanagable, they elected to instead replace the pumps when the vehicles were seen for service. Fathom's was one that failed prior to be replaced.

So, given that was a couple of years ago, one would assume all the pumps have been done by now.

Mitsubishi Challenger SUV, 2.5 turbo diesel, five speed sequential shift auto, 2WD, three tonne towing capacity :yes: Only thing is with the auto torque is reduced from 400nm to 350, no LSD but I assume that the electronics sort that out. Everything else looks good, these would be the cheapest diesel SUV with a serious towing capacity around, by a big margin.

Mitsubishi Challenger SUV, 2.5 turbo diesel, five speed sequential shift auto

Make sure you take it for a test drive - on a flat 100 - 110k road.

A guy here at work has the Triton version (diesel + auto) and it has a massive surge problem where it refuses to sit on 110... on a dead flat road, without moving your foot (or in cruise) it will hunt between 105 and 115. It has been back to Mitsubishi dozens of times over the last 2 years where they have swapped everything imaginable, including re-flashing the ECU with a custom program from MMC Japan... and then replacing it when they bricked it on one attempt.

I think he is basically now at the stage where he has given up on it and is just waiting till it is due to be replaced.

Apparently there was something strange about his combo from memory though, he appeared to get the motor from one series coupled to the GBox from a different series or something along those lines - not that it is actually changing gears when it happens.

Edited by samstain

The diesel Land Cruisers are not bullet proof despite what the Toyboys may like to think. Talking with a bloke out at Lakeside the other day, he bought one new and at 140K the fuel system dropped it's guts, had to be towed. Cost $7K to have it rebuilt. 650nm would make one a monster tow car though.

Mitsubishi Challenger SUV, 2.5 turbo diesel, five speed sequential shift auto, 2WD, three tonne towing capacity :yes: Only thing is with the auto torque is reduced from 400nm to 350, no LSD but I assume that the electronics sort that out. Everything else looks good, these would be the cheapest diesel SUV with a serious towing capacity around, by a big margin.

Interesting, had a look at the nt model pajero as well which looking at car sales is a slightly dearer price for an 09model about 30k

f**k just replaced the rubber on the q7

Nothing but the best china high load shit

780 fitted foR 4 tires. 275/45/20's

f**k yea

When did rubbeR get so cheap?

Cheap cheap!

I was surprised at how cheap you could get them too, especially for such a ridiculous size. I can get Yokies for under a grand. Crazy!

Make sure you take it for a test drive - on a flat 100 - 110k road.

A guy here at work has the Triton version (diesel + auto) and it has a massive surge problem where it refuses to sit on 110... on a dead flat road, without moving your foot (or in cruise) it will hunt between 105 and 115. It has been back to Mitsubishi dozens of times over the last 2 years where they have swapped everything imaginable, including re-flashing the ECU with a custom program from MMC Japan... and then replacing it when they bricked it on one attempt.

I think he is basically now at the stage where he has given up on it and is just waiting till it is due to be replaced.

Apparently there was something strange about his combo from memory though, he appeared to get the motor from one series coupled to the GBox from a different series or something along those lines - not that it is actually changing gears when it happens.

Does it happen to have a snorkel fitted?

I like your thinking, but no I don't think so... it is all very stock - just dealer fitted times such as a canopy and bull bar of some description from memory.

It would be interesting to see where the air intake for the stock air box is. I've seen certain 4WDs have them in a wheel arch, which caused pressure issues at speed.

Might be worth having said person investigate and see what happens if a snorkel is fitted (Or an air intake from somewhere else)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...