Jump to content
SAU Community

Recommended Posts

  • Replies 45
  • Created
  • Last Reply

Top Posters In This Topic

is this a joke? the only decent car in that shot is the silver GTR... and only because it looks the least molested out of the three (ie stock).

Both those cars in front have horrible fuckin wheels that make me wanna chunder. They've got nastyass fitment which makes me think they just got some shit that was meant to go on an Excel from Tempe Tyres and just bolted em in.

is this a joke? the only decent car in that shot is the silver GTR... and only because it looks the least molested out of the three (ie stock).

Both those cars in front have horrible fuckin wheels that make me wanna chunder. They've got nastyass fitment which makes me think they just got some shit that was meant to go on an Excel from Tempe Tyres and just bolted em in.

harsh but I agree

the gts-t ain't too bad but the wheels on that supra are an abortion wrapped in puke

edit: I clicked on the pic to zoom in, the gts-t is just as bad

Edited by Yo-Yo
also stuck it in the spotted thread! owner of the purple 33, you on here?? damn nice car dude!

If he was on here I am embarrassed for him, is it just me or should chrome wheels and skylines keep away from each other?

Your S3 is the best looking out of them all by a long way.

is this a joke? the only decent car in that shot is the silver GTR... and only because it looks the least molested out of the three (ie stock).

Both those cars in front have horrible f**kin wheels that make me wanna chunder. They've got nastyass fitment which makes me think they just got some shit that was meant to go on an Excel from Tempe Tyres and just bolted em in.

yeah i was about to say aye

for YEARS ive hated that big chrome bullshit.......even that dodgy paintjob..... thats disgusting....

looks like a typical fully sick hectic bro wheels, no style watsoever.

The way people in australia try to customise a car is SHOCKING compared to the jap

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...