Jump to content
SAU Community

Recommended Posts

  • Replies 226
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Sounds good, Shane. Will get the ball rolling tomorrow at work.

Matt if you see Luke with my old 34 at work, any chance you could ask him if he wants to be involved with the SAU display?

No harm in asking I suppose.

Shane, Am I still showing the R34 inside both days and if so who gets the forms, you or send in direct for the discount off ?

I need to send it in the next few days ??

Send the form in with the full amount and SAU-SA will give you the Discount on the weekend of the show.
Matt if you see Luke with my old 34 at work, any chance you could ask him if he wants to be involved with the SAU display?

No harm in asking I suppose.

Pete, will give it a shot mate. I have to head over his way tomorrow so will see if I can track him down and ask. If you can PM me his surname it will make the job easier, I'll know exactly which section to look for him.

I have filled in my entry form and will fax it off shortly.

well the time depends on what time we have to be there for set up and depending on times of people finishing wk etc?

i'm happy to meet at villies, not sure what time i will be finishing wk, but hopefully early that day (friday)

i believe i'm in the inside event?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...