Jump to content
SAU Community

Recommended Posts

  • Replies 226
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Sounds good, Shane. Will get the ball rolling tomorrow at work.

Matt if you see Luke with my old 34 at work, any chance you could ask him if he wants to be involved with the SAU display?

No harm in asking I suppose.

Shane, Am I still showing the R34 inside both days and if so who gets the forms, you or send in direct for the discount off ?

I need to send it in the next few days ??

Send the form in with the full amount and SAU-SA will give you the Discount on the weekend of the show.
Matt if you see Luke with my old 34 at work, any chance you could ask him if he wants to be involved with the SAU display?

No harm in asking I suppose.

Pete, will give it a shot mate. I have to head over his way tomorrow so will see if I can track him down and ask. If you can PM me his surname it will make the job easier, I'll know exactly which section to look for him.

I have filled in my entry form and will fax it off shortly.

well the time depends on what time we have to be there for set up and depending on times of people finishing wk etc?

i'm happy to meet at villies, not sure what time i will be finishing wk, but hopefully early that day (friday)

i believe i'm in the inside event?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
    • It's been quite the ordeal but hey, at least you figured it out.
    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
×
×
  • Create New...