Jump to content
SAU Community

Has Anybody Done A 1/4 Mile In Their R35?


Recommended Posts

Totally stock. Driver only, full tank. Launch at approx 2200 RPM.

How many runs did you do and what mode did you find works best?

Did you use manual or auto shift?

Did you use LC?

thx!

Edited by LSX-438
How many runs did you do and what mode did you find works best?

Did you use manual or auto shift?

Did you use LC?

thx!

I am planning a run at Eastern Creek in about three weeks with an ADM with HKS GT570 Kit plus Cobb Custom Tune installed. I will let you know the time soon...

How many runs did you do and what mode did you find works best?

Did you use manual or auto shift?

Did you use LC?

thx!

I had it set on RRR and let the car do the shifting. It was just the one run using RaceChrono software on my Nokia N95 with a Qstarz BT-Q890 nano 66 Ch 5Hz GPS receiver. It was 3.84 secs to 100 kph and the road was a bit dusty which may have helped, maybe not. Can't really tell but it spun a bit more than usual off the line but didn't bog as much as a result.

I stalled it a bit but not fully to 3000 rpm so again maybe theres a bit more to be had..

  • 2 weeks later...
Good work Duncan :)

Nice trap speed too!

Thanks Martin, yeah 125mph is haulin for such a heavy car.

Here is a 125mph run (11.3's though) ignore the reaction time as the driver was frigging around with launch control

  • 7 months later...
Hello All

Have any of you guys taken your R35 down the 1/4 mile yet? If so, what times have you recorded?

12.01 at 158mph (launch control)

Edited by caraddict
158mph? wow that's a new world record!

- must have been at Heathcote, lol.

lol,

11.92 at 194km/h @ Eastern Creek. (Not one good Launch control start)

Mid pipe only, terrible 0-100 times (4.1) They kept wetting the burnout area which I had to drive through.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...