Jump to content
SAU Community

Recommended Posts

Anyone interested might like to pick up a copy. Entertaining reading. Apparently all cars have been modded, some seriously (however the GTR ran basically stock times at the 1/4 mile, despite being tuned...). They ran some laps of Oran Park too... The GTR was beaten by the GT2 and Porsche by 0.5s and 0.2s respectively. The thing is, the GT2 was running hoosier r6's (basically slicks) and the Turbo was runninng Formula R Toyos. The GTR was running the OEM Bridgestones.... Why you would install $50k in mods and then run standard bridgestones isnt quite reality (if you're seriously interested in lap times that is). i know for a fact that the bridgestones are 2 seconds slower than r-specs on the GP circuit, which would easily translate into 1 second on south. Anyway, interesting reading nonetheless, but i reckon the GTR would have easily beaten the South times with equivilent tyres. In fact, i reckon even a standard GTR would have kicked the modded GT2 and Turbo's arses collectively, given the same tyres. Amazing really, given the price!

Edited by LSX-438
Link to comment
https://www.sau.com.au/forums/topic/288705-motor-magazine-extreme-tuners/
Share on other sites

I had just a quick flick through at the shop and noticed the power output listed of the "modified" GT-R... 258awkW estimated.

Don't they come with near 300awkW as standard? What are they doing?? :)

That car would've had somewhere approaching 345 at the wheels. They must have had Dyno dramas with it and stuffed up the estimate. I was surprised how slow it was given these mods. White 35 has 345 at the wheels and is pulling 3.3 0 - 100. Duncan did a 11.1 quarter mile in his with similar mods. My Mods were also a lot cheaper, and produced much better results also.

Maybe they babied the car, or it was hot, or boost was turned low...or something.

It says somewhere in the article they had dramas removing the carbon undertray which meant they couldnt dyno the car, probably due to clearance issues (or maybe they didnt want to get it dirty, lol). Maybe it has an aftermarket undertray? anyway i removed my complete undertray in my garage with $2 tools, so dunno what's up with that. And yeah it should have about 340awkw. Their estimates are a bit rubbery. Interesting article though.

I have the mag,

Reasons for slow times are due to the owner not letting them use launch control and as mentioned above stock rubber.

Hardly seems worth while entering a car in that type of comp then saying no to using all the gizmos on the car like launch control.

FYI check out the Golf R32 that city performance entered, $70k in mods, bloody crazy.

Yeah, that guy's letter in the August issue (Porshe choice) got me fired up & thought

I would say something! They always cut down the text though & made it read a bit nicer

than what I put down - haha. I suppose the response was that they printed it (my 2nd time)

Its a shame Willall couldnt get the Silver R35 with the Turbo upgrade in that shootout -

that would have been quite interesting. Nice body parts & all the internal goodies as well.

Yes it was a good article. Motor have been doing lots of "tuner" articles over the last few

years & it is the only magazine I buy regularly.

I agree about the launch - whats the point in putting it in but saying dont go for it?

Surely one or two full launches wont hurt it ( ah hem.. I have done a few with my full

JDM launch control with no problems)

I have the mag,

Reasons for slow times are due to the owner not letting them use launch control and as mentioned above stock rubber.

Hardly seems worth while entering a car in that type of comp then saying no to using all the gizmos on the car like launch control.

FYI check out the Golf R32 that city performance entered, $70k in mods, bloody crazy.

Overly careful owners like that does not help the erroneous belief being passed around by GTR 'haters' that the GTR's transmission is 'fragile'

Surely one LC will not hurt the transmission - especially when it's the revised LC where warranty is not void so long as VDC is not turned off. :ninja:

I had just a quick flick through at the shop and noticed the power output listed of the "modified" GT-R... 258awkW estimated.

Don't they come with near 300awkW as standard? What are they doing?? :)

From my memory of that article their estimates were based on a 30% drivetrain loss.....which sounds unusually high...obviously resulting in the lower rwks.

Willall just dynoed my R35 JDM on their 4 wheel dyno & it made 278 awkw standard.

Now waiting for results from new custom COBB tune with boost control. It is not unusual

for cars to vary on power level depending on kays & type of dyno used.

Willall just dynoed my R35 JDM on their 4 wheel dyno & it made 278 awkw standard.

Now waiting for results from new custom COBB tune with boost control. It is not unusual

for cars to vary on power level depending on kays & type of dyno used.

what was the boost level?

  • 1 month later...

Some of you may remember this shootout. An R35, with apparently $50k in mods, ran a 46.7 around Oran Park South. It was running the stocker bridgestone tyres. I think it was John Bowe driving. Compared to a 911T running 888's (46.5) and a GT2 running Hoosier A6's - which are essentially slicks, running the best time of 46.2.... ALL cars had various mods. The tyre thing gave me the shits though (i mean really, a GT2 on slicks vs an R35 on stocker bridgestones).

Anyway, i had a chance to run Oran Park South in my R35 with slicks recently....

Result=46.3

Now, i dont have $50k in mods, and i am not John Bowe. I have less than $10k in mods (Willall midpipe, tune, 18" wheels and tyres). In fact, it's about $5k really, as i was using cheapie 2nd hand slicks on the day. Michelin p-cup 270/68/18's.

What does this tell us?

a) The GTR is one awesome machine, proven capable and comparable to the 911T and GT2 at a fraction of the cost.

b) You dont need to spend $50k on mods, in fact you'll probably make it go slower (if done merely for bling factor)

c) For track excursions, the No.1 most important mod is... TYRES.

Edited by LSX-438
Some of you may remember this shootout. An R35, with apparently $50k in mods, ran a 46.7 around Oran Park South. It was running the stocker bridgestone tyres. I think it was John Bowe driving. Compared to a 911T running 888's (46.5) and a GT2 running Hoosier A6's - which are essentially slicks, running the best time of 46.2.... ALL cars had various mods. The tyre thing gave me the shits though (i mean really, a GT2 on slicks vs an R35 on stocker bridgestones).

Anyway, i had a chance to run Oran Park South in my R35 with slicks recently....

Result=46.3

Now, i dont have $50k in mods, and i am not John Bowe. I have less than $10k in mods (Willall midpipe, tune, 18" wheels and tyres). In fact, it's about $5k really, as i was using cheapie 2nd hand slicks on the day. Michelin p-cup 270/68/18's.

What does this tell us?

a) The GTR is one awesome machine, proven capable and comparable to the 911T and GT2 at a fraction of the cost.

b) You dont need to spend $50k on mods, in fact you'll probably make it go slower (if done merely for bling factor)

c) For track excursions, the No.1 most important mod is... TYRES.

Agreed, in fact I have 19 inch Volks on the way wrapped in Hoosiers - look out Bathurst a two twenty something is in my sights...

  • 2 weeks later...
  • 2 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
    • Shock tower brace is in +5Kw....LOL  
×
×
  • Create New...