Jump to content
SAU Community

Recommended Posts

.... also spotted a silver 33 on george st about 20mins around.. he was at the 3 wide monkeys pub and liverpool st lights.... :wavey:

around and wide.

you have a fat complex

anyone go to WSID on wed?

i was there watching and saw some nice skylines

Yeah i was there, wish i took out my car as there was no one racing.

Some nice skylines out, i liked the R33 S2 Gts-t which had a nice high mount on it. Was in very nice condition too.

The blue 33 GTR was doing 12.1's and maybe a 11.9 i think(he seemed very happy when i was down in the pits) and there didn't seem to be much done to it engine wise. My knowledge of RB26's is not the best so i maybe wrong.

I see "Nur" quite a bit around town, twice this week in fact this week on my way to work in the mornings.

I assume its the legit Nur edition?

Dude, if you see me, i'm in the white r33 drooling hehe. Nice clean car and love the spoiler

Props for using a car like that as a daily driver

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...