Jump to content
SAU Community

Recommended Posts

wilch - looks awesome mate!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

I spotted ben - rb30gtr hooning on the posie bike >_<

and few mins before spotted burnsie both on pacific hwy mt colah and berowra

Spotted Thomas on Victoria Rd zooming past, then spotted him at powerplay. Nice rims :D

Spotted a black 33 with standard plates kingsford going up rainbow street from the 9ways round about around 6pm.

So many lines esp dark ones in this area now. sux0rs :) Might have to respray the car blue or something. :

Me? hahaha why dont i ever get spotted :D HATE YOU TURDY :(

Spotted a black 33 on botany road kingsford last night around 7ish?

I dont think it was you turdy was it?

I HATE YOU TOO :D

Nope not me, and there is a botany road @ kingsford? >_<

Spotted about a dozen kids at a bus stop all look and point at my car excitedly saying, "fast & the furious!!"

:huh::D

stupid kids.

hahahahaha haahahahaha

did you do a hektik d0rift0 in front of them?

:( hehehehehe

Spotted about a dozen kids at a bus stop all look and point at my car excitedly saying, "fast & the furious!!"

:wave::)

stupid kids.

hahahahaha

another classic moment to add to your collection

Yep it didnt sound normal I was in a older 3 series beamer not a new one you were busy on the phone and checking things in the car....Sorry I need to work on my sentences

You look younger than I thought you would be

:)

I'm 23

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Did and sync timing with light 
    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
×
×
  • Create New...