Jump to content
SAU Community

Recommended Posts

Seen a grey 32 at Bungarrabie roundabout thismorning....Looked gey with black lip??? he gave me a wave...sweet!

Then a white 33 turning off Vardy's rd onto Davis rd Marayong both on the way to work this morning.He waved too.

I should drive the line more often.

Spotted a grey 33 on Harris RD Five Dock. Guy was getting out and was either stoned, had just woken up or was very very confused because all I got was a glare in response from my nod.

Also saw a beautiful looking Silver R32 GTR as I turned right off Concord Rd onto Homebush Bay Drive just after 12pm. He was heading south and sitting at the lights. SOOOO CLEAN! Gave a thumbs up and got a nod in return.

yesterday spotted a black/dark grey r32 gtr at giffnock avenue maquarrie park about 11am with plates RB VIP or RB RIP, i flashed and he waved, mean looking car that one....

last night bout 8ish going down davies road through bankstown bout 7.30pm there was a red p plater in 4 door r34 non turbo, blue or silver colour that i couldnt catch up to in my lightly tuned gtsT get done in the bum after what looked like he drove into something on the road like a pot plant or a trucks retread tyre and it was wedged under his car, or someting at the front of his car fell off and got stuck.... anyway if your on here slow down abit for your own safty and less damage to your car.

afterwards alfords point road white series 2 r33 gtst was following me for a bit

cheers all

yesterday spotted a black/dark grey r32 gtr at giffnock avenue maquarrie park about 11am with plates RB VIP or RB RIP, i flashed and he waved, mean looking car that one....

That was me bro. Nice R33 you have dude.. looked good.

Plates are RIP V8 :D

That was me bro. Nice R33 you have dude.. looked good.

Plates are RIP V8 :P

hahaha thanks,,,,, cut me sum slack i just got back from europe and i was driving to work (last place i want to be) lol, im still in holliday mode, number plate is even better sounding now, i love it

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Have you done the Ignition Sync Wizard in the AEM software?
    • Find out what RPM it was idling at with the IACV unplugged. It's very weird that the rpm didn't change at all, and then it stalled. When it stalls is it nearly like a switch off, like you've turned the engine off? Or is it more stutters and sputters and coughs to death over a few seconds? Or does the RPM just slowly keep going down and down? Have you done a test of trying to start it with the AFM unplugged? Does it still die?     If you Follow Josh's advice on using Nistune to check the voltages (which is a perfect method!) if you see anything out of wack voltage wise, THEN get the multimeter out and read the voltage directly at the sensor. If the two vary, then you're now looking for a wiring issue vs a sensor issue. So be aware, what the ECU sees, may not be what the sensor is actually saying too...
    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
×
×
  • Create New...