Jump to content
SAU Community

Recommended Posts

oh yea thats right i remember hearing about the series 6

isnt that pic in ur avatar his old 180?

i remeber seeing that thing on the dyno at autosalon years ago

Yeh thats the same 180sx but its mine now and a lot different and of course more KW at the rear, heeh just got the thing out on the road the other day. after alot of pulling hair out i finaly have finished it .

Saw a red '33 Gtst today, "MENAGE" (i think) in Tuggerah

That's my mate Rob, he doesn't use the forums.

I followed, then drove infront of a silver SII R33 this morning on the M4 east bound from Cumberland HWY up until parramatta rd at the end of the M4. Plates were APU-66U. I was in a black Accord Euro.

Nice car dude!

i saw a nice white r33 gtr on king georges road coming from macquarie , The hid light on that car was nice and the the car look nice with a black lip i think the no. plates is pik-11e but doubt it will be right ...... next time you see me give me a wave .. i am in my r32 gtr white

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • 9" wheels are a little too wide for a RWD 32. They can fit. People have put R33 GTR wheels on 32s for years and years. But they are a very tight squeeze. This has been known for about 30 years. As I said - there is no difference between a 17 and an 18 in terms of what will fit. The rolling diameter needs to stay about the same as stock - not very much larger. If you increase that, you will start to have problems. If you increae rolling diamater at the same time as yo increase width, you will have problems earlier. as 9" wheels are pushing the boundaries already, you would need to be careful with tyre choice. I would put 8.5s on the front of mine, but would expect problems with 9s.
    • post up screen shots of your injector tables
    • Diagnostic flow for a code 21 says check signal at the ECU pins, on a voltmeter of some kind it should read 0.1V at idle, 0.12V cranking, 0.15-0.25V at 2000 rpm. Check each coil such that +1, -3 is infinite or very high resistance, -3, +2 should do the same. (-1, +3), (+3, -2), (+1, -2), and (-1, +2) should all be somewhere between 0 ohms and high resistance. If you trace the path from the coil pin all the way back to the ECU in the diagram the resistance you measure at the coil vs connected to the harness should be pretty much the same. 
    • I have an elite 2500 running an adapter harness on an rb25de neo r34. I took the butterfly out and removed all that junk. But I also went Plus+t at the same time. The butterfly thing works in reverse to the boost solenoid on the Gtt if that makes sense
    • yeh they are 235/45/17 up front and 255/40/17 in the rears. I still didn't get my answer if i can fit a 18x9 up front. I want to get 4 of this and see if they will fit before committing as they didn't see an 18x8 as an option but there is a 18x9.5 also.   Enkei RS05-RR 18x9 35mm ET 5x114.3 75.0 Bore Matte Gunmetal Wheel
×
×
  • Create New...