Jump to content
SAU Community

Recommended Posts

heh, you always spot that one,

spotted heaps of lines the past couple of days, waved to most and they returned, no one familiar to me though, amazing how man lines you see when you drive around in the day instead of working

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/257/#findComment-1813936
Share on other sites

Spotted my car's doorhandle laying on the ground next to it completely f**ked when I came out of work. Some little f**ker hacked it out with scissors, leaving me a nice, big, bent, scratched hole where the handle should be. Thank f**k my alarm sent the bastard running before they could get anything from the car.

f**kf**kf**kf**k >>_+[iPDFSGUO;w{hGF

Just what I wanted for christmas, a repair bill courtesy of some stupid arsehole.

door.jpg

Edited by Sauce
Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/257/#findComment-1814580
Share on other sites

Spotted yesterday a black R33 with NSW plates and big FMIC near Bunnings in tuggers. He waved at me as i stared but didnt get a chance to wave back. Waited for him to catch up and tried to wave but he didn't see. Anyways, IMMACULATE looking car, i was in awe! I want my baby to look like that!

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/257/#findComment-1814816
Share on other sites

How many rear wheel kilowatts does your car have Andrew??? :(

less than yours, im running more boost too :(:(

Sauce, that really sux dude, what sort of person does that sort of shit? spesh at this time of the year :)

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/257/#findComment-1814890
Share on other sites

Spotted about 25 minutes ago:South bound white R33 GTS-T on Lanyon Drive-A.C.T. plates mounted on the lefthand of the 'bar,FMIC,that short low boot extension type wing driving like a bonehead. Weaving through the traffic,he nearly sideswiped the GT-R before ripping through the Jerra' roundabout...Christmas day,double demerit points,every tourist and his mutt driving along in la-la land...and someone wants to play "boost-hero racer" with the rolling chicanes?!? If this happens to be one that frequents this forum,or if someone knows the owner,drop me a P.M.;I'd really like a "quiet word" in your ear...

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/257/#findComment-1815241
Share on other sites

Spotted about 25 minutes ago:South bound white R33 GTS-T on Lanyon Drive-A.C.T. plates mounted on the lefthand of the 'bar,FMIC,that short low boot extension type wing driving like a bonehead. Weaving through the traffic,he nearly sideswiped the GT-R before ripping through the Jerra' roundabout...Christmas day,double demerit points,every tourist and his mutt driving along in la-la land...and someone wants to play "boost-hero racer" with the rolling chicanes?!? If this happens to be one that frequents this forum,or if someone knows the owner,drop me a P.M.;I'd really like a "quiet word" in your ear...

Boost-hero racer!!! HAHAHAHAHA! :lol:

great way to put it jayce! some people arent too smart are they......

Sauce, sorry to hear and see that man. what a pain in the arse......

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/257/#findComment-1815741
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
    • For race cars, this is one part where I find having the roll cage bar having gone through a hole in the floor better than the build it up on a ledge inside... The Merc I help on, the main hoop ends are marked on the car, and the jack is marked... Jack goes under a few inches and lifts one whole side of the car up... Removes that fight for long slim jacks for race car duties!   My biggest issue for the daily drivers I work on, is my jacks don't go high enough. The jacks start out on a few blocks, jack it up, then start a second jack under it on more blocks, and then I can get an axle stand under it. My axle stands are presently in use, and are nearly fully extended. The car is sitting with barely more than a cm of clearance to get the wheel off the studs! Sarah's Kluger is the same, as it has an ungodly amount of droop available in the suspension and a distinct lack of good jacking points!
    • Happy? Yep, my to do list is getting shorter and shorter. Either this light approaching is the end of the tunnel, or I'm about to be hit by a train... Ha ha ha   Also, Duncan isn't that far out of town that you need to make a multi day drive out of it. 😛
    • Sorry I meant that we are building the EH for a client.
    • LOL, when one "money pit" is never enough Noice, and excellent work mate
×
×
  • Create New...