Jump to content
SAU Community

Recommended Posts

spotted me with too much time on my hands.. need to join another forum!! not a skyline, but the stylish (and better looking) little brother, S15 200sx..

settle, settle, just jokes!!

better get my R33, R34 spotting skills sorted.. easy with sils, bit more to it with Skylines..

oh, and spotted low200 sat morning on Yamba I think :ph34r:

Hey Alex!

Yeh it was me! i was going to a mates to carpool out to paintball :pirate:

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/399/#findComment-3025679
Share on other sites

IS A?O-2?A here? NSW plated white R33 GTST.

not very impressed with him.

last night 7.20pm intersection of Northbourne and Barry drive in the city.

I was in my orange FTO and he came up next to me and started reving the engine. I wasn't in the mood to do any runs infront of a red light and speed camera and it wouldn't of been much of a challenge for a 2.5 turbo RWD car vs a 2 litre FWD, so he went off with a squeel of the rear tyres.

that doesn't bother me at all.

now what annoyed me was that later on he drove infront of me and slowed down to 40 on Northborne forcing me to slow down, I dropped to 40 for about 20 seconds and decided to change lanes and over take him. As I speed up and wanted to get back in the lane before the belconnen turn off he speed up again and stayed beside me forcing me to to slow down again so I can turn.

Seriously grow up. Damn I wish I had the GTR back on the road. actually this should go on 'things that sh&t me thread'

Edited by yaf28f
Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/399/#findComment-3029257
Share on other sites

2 things.

First you saw a knob - grats!

Second - i think we frown on publishing peoples number plates here.

Whoops, sorry, didn't think about that, number plate edited alittle. but still wasn't too impressed either way.

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/399/#findComment-3029419
Share on other sites

a silver R33 at erindale maccas round 10.30 lastnight.

that was me. was waiting for a mate... geez, thats 1st time i've been spotted in a while.... i dont recall seeing a onevia though. however, i was tired and wasn't really paying that much attention to the world around me!

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/399/#findComment-3030985
Share on other sites

that was me. was waiting for a mate... geez, thats 1st time i've been spotted in a while.... i dont recall seeing a onevia though. however, i was tired and wasn't really paying that much attention to the world around me!

Yeah you were next to a VL it was white i think. i drove straight past you and parked then another S13 pulled in.

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/399/#findComment-3032674
Share on other sites

Saw white series II R33 heading off tuggers parkway onto livingston i think its called at about 7:20pm tonight (turning right at the start of Kambah)..

Who owns this? Looked very nice and clean, nice note too - i would like to see more pics - the front bar looked stock-ish maybe a tommy bar or similar i only caught a very small glimpse ...looked much nicer than mine though :thumbsup:

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/399/#findComment-3035304
Share on other sites

Spotted a white 32 heading down the Barton HWY away from Canberra, didnt see rego plates so not sure if Canberran. Also did anyone else driving today notice how many morons were on the road today... I hate zigzagging through traffic and always avoid it but there were atleast 7 consecutive cars all doing 20km under (60 in an 80 zone) sitting in both lanes. Why do people go slower then the limit when the conditions are perfect and why do people sit in the right lane and go slower!... hate it so much

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/399/#findComment-3035319
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...