Jump to content
SAU Community

Recommended Posts

hahaha fair enough :P

Just break them down into relevant bits - the Y will almost always be meaningless since it's compulsory for standard plates; the following 5 characters might form a word (very, very obscurely in most cases lol), if they don't then consider them to be an abbreviation of a word or perhaps an acronym. Look at the numbers - have they any relevance? In this case, yes - it's an R33. Back to the letters now the numbers can be ignored: YGT-33S....GTS is almost GTS-T lol.

THIS SHIT SHOULD BE A SCIENCE OR AT LEAST A SUBJECT YOU CAN STUDY IN SCHOOL, like all those pointless arts subjects lol

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/878/#findComment-7075253
Share on other sites

Spotted who I believe to be DJBarnstar turning off the Monaro into Fyshwick earlier. I was behind on the bike.

Also spotted myself being uhh...yeah pulled over for speeding. Yeah yeah yeah, no excuses....though in my defence it was right as the limit went from 90 > 60 and I was paying much more attention to the numpties in front of me :(

Yes I still have my license lol

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/878/#findComment-7075739
Share on other sites

95 in a 60 zone. $664 and 4 points.

Learner on a bike exceeding power to weight limit. $135 and no points (thank fuark).

Silly me....dunno how to feel given I wasn't intentionally exceeding the limit lol. Obviously I'm in the wrong though >.<

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/878/#findComment-7075800
Share on other sites

sorry to hear that Troy

Bikes just go faster easier and there should be a 40Kmh allowance for motorcycles :thumbsup:

as for power to wheight - that's just a silly law.

as if you cant kill yourself on a learner legal just as easy

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/878/#findComment-7075831
Share on other sites

sorry to hear that Troy

Bikes just go faster easier and there should be a 40Kmh allowance for motorcycles :thumbsup:

as for power to wheight - that's just a silly law.

as if you cant kill yourself on a learner legal just as easy

Yeah, it is a bloody stupid law. There should be a competency test you can take after say 3 months of riding that removes restrictions on your license, given I've seen some fully licensed riders who don't have a clue what they're doing, as well as the fact you touched on that you can write yourself off on a gutless postie bike.

I'm just pissed coz of the circumstances I was exceeding the limit - the f**king clowns in front of me dead set had no f**king idea what they were doing. I gave it a blat to overtake them (thinking it was still 90kph) the moment I got a chance, for my own safety. Alas, this was my undoing lol

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/878/#findComment-7075849
Share on other sites

hahaha fair enough :P

Just break them down into relevant bits - the Y will almost always be meaningless since it's compulsory for standard plates; the following 5 characters might form a word (very, very obscurely in most cases lol), if they don't then consider them to be an abbreviation of a word or perhaps an acronym. Look at the numbers

Mine will read YMY-70Y

Been on my last two cars and briefly on the wife's car lol

I have to behave driving, my points are low and as I drive a truck interstate for my job I really can't afford to loose it

However someone called my boss and complained about my driving :/ my boss wasn't concerned at all luckily...

Link to comment
https://www.sau.com.au/forums/topic/30059-spotted/page/878/#findComment-7075985
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
    • For race cars, this is one part where I find having the roll cage bar having gone through a hole in the floor better than the build it up on a ledge inside... The Merc I help on, the main hoop ends are marked on the car, and the jack is marked... Jack goes under a few inches and lifts one whole side of the car up... Removes that fight for long slim jacks for race car duties!   My biggest issue for the daily drivers I work on, is my jacks don't go high enough. The jacks start out on a few blocks, jack it up, then start a second jack under it on more blocks, and then I can get an axle stand under it. My axle stands are presently in use, and are nearly fully extended. The car is sitting with barely more than a cm of clearance to get the wheel off the studs! Sarah's Kluger is the same, as it has an ungodly amount of droop available in the suspension and a distinct lack of good jacking points!
    • Happy? Yep, my to do list is getting shorter and shorter. Either this light approaching is the end of the tunnel, or I'm about to be hit by a train... Ha ha ha   Also, Duncan isn't that far out of town that you need to make a multi day drive out of it. 😛
    • Sorry I meant that we are building the EH for a client.
    • LOL, when one "money pit" is never enough Noice, and excellent work mate
×
×
  • Create New...