Jump to content
SAU Community

Recommended Posts

  • Replies 107
  • Created
  • Last Reply

Top Posters In This Topic

If you're experiencing bad fuel economy, try replacing the oxygen sensor if it hasn't been replaced in the last 50,000km (or if you don't know whether it has been replaced or not). $120ish item, extra 100km to a tank...and it's quite common for them to be worn out.

lol... not too many 300rwkw cars running an O2 sensor mang....

mine got disabled years ago

oh and FWIW i get ~350 per tank... (RB25 @ 285rwkw/19ps)

lol... not too many 300rwkw cars running an O2 sensor mang....

mine got disabled years ago

oh and FWIW i get ~350 per tank... (RB25 @ 285rwkw/19ps)

Ahh read thread ffs. I didn't direct that at Chris or I would have quoted him!

I'm burning up here.

:P

lol... not too many 300rwkw cars running an O2 sensor mang....

mine got disabled years ago

oh and FWIW i get ~350 per tank... (RB25 @ 285rwkw/19ps)

out of interest, why dont/cant you run an o2 sensor?

Edited by Peter89
My car is doing 0km per 0L at the moment >.> Too busy sitting on a train that smells like bad breath.

Which train you catching at the moment, Chuck? I'm working in the city now so am training to work at the moment.

Although I'm taking a squizz at a 98 zx9 tomorrow (kawasaki...*shudder*) so this may be my last day on 84 wheels!

lol...

Peter - RE: O2 sensors, if the tuner has adjusted all the cells sufficiently, the O2 sensor can be made redundant.

All the O2 really does it on light load leans off mix and so on by way of mapping. Nothing you cannot do via a tune in the light throttle/load cells far as i understand it.

My car generally gets as good or better economy than cars with less power and O2 sensors :P

Ok,

My fuel economy is 'I don't care'

What I do is put petrol in the tank, drive it and fill it up when it's almost empty.

Simple really.

  • 1 month later...
Mine is pretty poor!! I am getting about 19-21 L/100ks

I am ALWAYS at the petrol station!!!

:D not so flash for the wallet

You need to get the car check ASAP if you haven't done so already. You are spending too much money unnecessarily on petrol. Skylines can do much better than that.

Comparison for fuel consumption is a good exercise because you get to see how well most Skylines run over time, especially with such contrasting setups. The newer cars like the R34 should have better fuel economy, whereas the older models if well maintained/serviced should perform almost as good. 400-450km to a tank sounds like the average for skyline drivers.

During my drive to Sydney I managed to get over 600km to a tank on V-Power and about the same amount on the drive back to Melbourne. This is a stockish untuned R32 GTR and driving a constant 110km/h in 5th gear (which every GTR should be able to do or better).

My next car BTW is going to be an R35 GTR, it averages 12.7 lt\100km and goes waaaaaaay faster than my car.

you drive a roadtrain?

Actually I did the maths wrong. It's 96 wheels :)

6 carriage train, 16 wheels per carriage :D

But I'm doing the 2 wheel commute now. Sooo much faster, and more fun, than 96.

If anyone sees a blue '98 ZX9 weaving through traffic somewhere between Hurstbridge, Ivanhoe and the City (Collins St) gizza wave, and get outta my way :)

For some reasons, I seemed to get more k's from a tank of 95 than a tank of V-power, why is that?

Difference is 10.5L and 12L

maybe you drive it a bit different because you know you just put in shitter fuel?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...