Jump to content
SAU Community

Recommended Posts

yeh thats what i saw when i looked

18x9.5 +20 rota grids

with a 20mm spacer on front its now 18x9.5 +/-0

and a 15mm spacer on rear its now 18x9.5 +5

NT033.jpg

VoltexEvo8.jpg

ewww both these cars are running voltex widebodies, the rear quarter bolt on sections are shit as

:P this is the wastelandz you idjit. thread only ends when it get too big (approx 1000pgs) and funky makes a new one

i knooooooooooooooooooooo

miss the point much :)

yeh the te's are huge im diggin the bbs if u rock that stance though if u dont slam it like that will llook pox

why would u bother ? if u want stilts get some 4x2 from bunnings haha..

nah do it once do it right go baller cos most evo's fail that i see

haha they do, most run about what ive got now 8.5 +35 or 8 +38

the 9 +17 wil be a near perfect fit any wider/lower offset itll rub bad and i dont wana flare

get some adjustable coilovers and rise it higher, and then use it for what it was meant for and find some dirt tracks for some rally goodness :) .

i live on a dirt road, but i hate driving on it

i like clean cars, ive taken it down the road once it was soooo filthy afterwoods and dust was in everything.... never again

now snow.... thats a different story..... common winter :P

i live on a dirt road, but i hate driving on it

i like clean cars, ive taken it down the road once it was soooo filthy afterwoods and dust was in everything.... never again

now snow.... thats a different story..... common winter :)

im the same, i hate hearing the stones flick up and you hear them hitting your car, it makes me cry.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
    • Yeah - I mean, go the other way. Smaller range. Not larger.
×
×
  • Create New...