Jump to content
SAU Community

Recommended Posts

Try maccas... Lol

Check websites of retailers you want to apply for. Most don't use seek, they accept applications through their websites. That's how I got a job at Supercheap Auto :)

thanks, whats involved in working at supercheap?

Yeah. The gearbox/driveshaft etc. are all stock still (1990 ADM) so it looks like the best thing to do is buy a late model turbo halfcut and take the gearbox/diff off that.

Other than that the mechanic said it was a very healthy car, very straight body etc.

He couldn't believe the price I got it for :blink:

Yeah. The gearbox/driveshaft etc. are all stock still (1990 ADM) so it looks like the best thing to do is buy a late model turbo halfcut and take the gearbox/diff off that.

Other than that the mechanic said it was a very healthy car, very straight body etc.

He couldn't believe the price I got it for :blink:

or use the camry gearset I posted earlier

you want to buy a halfcut to take the gearbox out? :blink:

bahaha.

Nah, I need the diff and all that shit too. Then sell off the rest of the halfcut and get most of the money back.

It's the best way to do it IMO.

Find me a gen 3 gearbox, driveshaft and diff then :( I bet you won't be able to. A halfcut is like $2500 and I can sell the engine alone for like $2000.

no, what you will end up with is a halfcut sitting in your garage for a bit over a year while cheap fuckers vulture shit off you. Most nga's who you think want to swap an engine will also want the gearbox and drivetrain to go with it, just like you do.

But hey, if you wanna sink 2.5k and not see the 2k you intend to make back in your pocket for a while then go nuts. If I were you, I'd spend a little extra and grab just the stuff you need.

Just sayin from experience.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...