Jump to content
SAU Community

Recommended Posts

man nissan's lagging in the aftermarket race.

just ordered a full suspension arm, bushing and bearing refresh kit for $600 for the golf. They even package it into a kit based on your VIN so all the parts are guranteed to fit. That's crazy.

No one has suggestions for a daily driver to cart my hairy arse around?

golf

I'm looking at JZX100 later.

coz that's such an intelligent choice for a daily

I wanted something a bit fun though.

clearly you've never driven a GTI.

coz that's such an intelligent choice for a daily

I'm not normal to begin with...

clearly you've never driven a GTI.

Correct, show me where can I get GTI for $13k and less?

Hamish, for 13k, I'd want you to throw in your GTST to sweeten the deal.

Nice try grant :down:

Dang it!

Looked at the JZX100 earlier, it hasn't been started for 4 months, seller basically let it sit after getting defected...

So would Supra make a good daily driver?

try this one by this guy. You should be able to knock a couple of grand off.

While I was searching... it's doable for me to find one at my price range, was surprised at how much these are.

But it does look bit boring though (don't care about police attention - never get pulled over in Skyline so don't mind flashy cars).

May have a squizz at one of these and see how I feel about them.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...