Jump to content
SAU Community

Recommended Posts

considering the showie nature of his car doubt he going to pop rivet into his rear bar

then he's doin the right thing by not running a decat.

if you're gonna do it, go double the fist and do it properly. the only thing that a cf heat shield will retard is your bank balance.

Haha aliminium sheeting to protect bar... But your putting holes in it :D defeats the purpose

would rather have a few small holes than a massive burn

my car shoots massive flames.. it IS a 989fwkw monster after all :(

Cataylic converters is for homosexuals.

Real man runs cat-less...

I just let the black soot build up on bumper and tell people 'it adds character'

My car shoots flames all the time and my bar doesn't get burnt. Just all the carbon build up makes the bar black
If it doesn't burn your bar.. just polish it more often? The shields look ghey.

I'm tossing up whether or not to punch mine out

+1 to this. My paint is fine :)

it is gay...thats why its not in my list of phone i can consider to get for myself soon..

what did u end up choosing?

tbh, i would go into a store and test them both, jbhifi has the htc desire to test

are you gonna buy outright? you going with telstra?

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...