Jump to content
SAU Community

Recommended Posts

indeed...it just makes it harder to have a car that can compete in multiple disciplines, which in turn discourages competitors. No doubt many of the rules are a very outdated attempt to keep very old cars competitive.

But ultimately, if one class (SV) is half your entry list then something needs to be done.

When I run CAMS there are going to be 3 classes:

* Production Cars (run under current rules, they are fine for what they are). Also Tarmac Rally cars. Standard turbos, standard boost, standard size wheels, standard injectors/fuel pumps, afms. Currently an evo gift but they are the best production cars around right now. Measured and sealed motor required for racing. Pump Fuel only

* Improved Production Cars (same as current rules but no intake restrictor. Their competitor numbers would go through the roof over night. Yes the 6 rx7s would have to retire but it is ludicrous that they are the only car that can win under current rules). Main limit on performance here is standard size wheels. Pump fuel or e85 only

* Sports Sedans (current rules except 4wd do not have the ridiculous "can't modify the floorpan" rules. weight limits per capacity class is enough). Pump fuel, e85, race fuel, methanol, whatever...anything goes

Those rules would be perfect for supersprints/superlap, hillclimb and racing....break down by class and capacity if necessary....one set of rules to bind them all!

BTW my rules would certainly allow active aero in sports sedans. As per current, no changes to prod cars and minimal, fixed changes to aero in IPRA.

Ok I have been competing in supersprints in NSW since 1999 was only 16 back then but have learnt a lot, so been there and seen a lot of rule changes over the years, and my has been supersprinting since father since 1992.

Yes we all know my father in on the CAMS Panel but only for the last 6 years or so. The reason the rules changed over the years is due to cheaters and keeping all classes competitive for all cars.

Back in the 90’s there was not to much that could beat a Clubman at the race track and we had a massive turn out of them at each round, they used to run in type 1,2,3 and 4 on slicks so you could image it would start to shit fellow competitors, also there was some WRX showing up in Type 2 with an exhaust and suspension mods claiming there boost was stock. At the end of the day you noticed that other cars starting dropping away and not showing up, like MX5, Commodores ect. Yes it was great for Clubmans and Turbo 4WD but I think if there was no change it would have pissed a lot of other people off. So this is when Small Volume (Type SV) comes along.

I know this is a skyline forums so everyone here wants them to win but think of the other competitors running MX5, Holden’s, or even in type 3 Ipra cars, you can’t expect a under 2liter ipra car run to against a clubman or Duncan in his R32 Production race car up against a road car without a out boost restrictor and claiming they run stock boost with a hidden switch YES it has happened. So they got put in Type SV. If we allow EVO’s, GTR’S and Clubmans back into all other types would only piss more people off that who are unhappy now.

In regards to the hill climb rules, Stuart maybe you can inform me of the rules if they have change and have Type SV? As I really don’t know and would like to as i was going to do a few hill climbs again soon, but my brother still holds the record at Huntly for type 2 0-1600 in the PRB on road tyres, I doubt it will be broken by a production car it’s a bit unfair really.

Ok I have written enough now of why SV is around and its to keep other people showing up or we would have the NSW Clubman & GTR- EVO championship in every type well that’s my thoughts....

  • Replies 161
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Well back to some chit chat about work getting done on cars, with still over a month till the next round what work are people up too, any new mods?

Im fitting a new race seat, and will try a bigger fuel pump, jetting on the weber and some dyno time so I don’t run out of fuel down the straight. Hope to get into the 1:47 then.

Enough rules and regs talk, it distracts us from remembering why we like supersprints so much. For me I love getting out there and getting the absoulute maximum out of my car and my abilities. I'm constantly searching for that perfect lap. Quite a challenge.

With the silvia, I'm looking at 2.2 stroker kit, forged internals, 600hp turbo, external gate running 30 psi, PPG gearset, carbon fibre panels, full aero work. The list goes on. Wait! I'm dreaming..lol!!! Not going to happen before next round, but would love to have all those mods one day. Yes one day....

Seriously, the only thing I'll be doing will be putting fuel in it and might give it a wash.

Oh and I would love to get down to 1:45's around the creek, but will be happy if I beat my PB of 1:47.5

BTW, mods sound good Brian. The R100 is a fun little race car.

Edited by nismoman

Just wondering if anyone knows what's going on at the end of year for presentation, where is it being held and when?

I heard last year it was held at Marulan Driver Training Centre and people I spoke to who attended really enjoyed it. I was hoping it would be the same this year?

Can someone please turn off this bloody cold weather so I can at least go out into the garage during the week and work out why I don't have any bloody spark at the coils.

Evil glad to hear your up and running again mate,,,great stuff.

Neil.

Can someone please turn off this bloody cold weather so I can at least go out into the garage during the week and work out why I don't have any bloody spark at the coils.

Evil glad to hear your up and running again mate,,,great stuff.

Neil.

Talking about the weather - bloody last 3 days -6 to -8's thats correct less than zero, middle of the day hasnt been over 9 degrees - buts its looking good - forecast is snow Friday and Saturday

Neil hope you get your wiring sorted out, for EC next round - long range forecast is rain, so an extra wire for a windscreen wiper might be handy.

I have got a big bottle of rainex I can tip on you if you park too close lol

Let us know how you go

  • 2 weeks later...

So...

How do I enter the 8th August sprint?

Need more practice...bit rusty after 7 months out of the game! 2 seconds off my PB :D

Boxhead - what happened yesterday? I saw you about to head out, was going to introduce myself after your session then I saw the car at back of skid pan?

All good?

Sure am! Put my form in a couple of weeks back. Can't wait! Look forward to seeing you there.

Hope my tyres last, Eastern Creek punishes my front right and both rears compared to Wakefield.

I'm going to dial in some more negative camber on the front to try and help. The front right shoulder really cops it.

Edited by nismoman
Can someone please turn off this bloody cold weather so I can at least go out into the garage during the week and work out why I don't have any bloody spark at the coils.

Evil glad to hear your up and running again mate,,,great stuff.

Neil.

Hi Neil

Hows the spark going???? Weather's been a bit nicer - you must have found an issue by now! Oh by the way, had some confirmation - ss panel, you can run 4d with slicks stepping up from Type SV, thus, you not having to comply with part of the following 4D based 3D rules

1. Over 6ltr

2. Traction control

3. Paddle gear shift

4. Roll Cage

5. Electronic Aero

6. Log Book

7. Window Net

8. Seats and Harness

and yet to run SV vehicle must be road registered, pending on model of vehicle - this can get tricky eg if the compliance plate states 4 seater / ADRs, air bags etc - this must be maintained, although CAMs approve the removal of rear seat for fitment of rollcage for safety factor, but bugger me 4D isnt a CAMs class anyway and so on !! and apparently by the way - SV doesnt stand for Special Vehicle - this year it is now Small Volume and under the CAMs manual based on 3J, therefore requires no seats, no road registration, but thats only if you want to run state hillclimb, Aussie HC, Aussie SS, world time attack or open race meeting in Australia or Tamania, but does not comply with NSW Supersprints.

Sorry to say, Small Volume / sorry Special Vehicle class did take 5 years to get going and was one of the biggest fields in Hillclimbs and Supersprints - looks like someone f$## it up

Cheers - thats all I know !!

Oh by the way, had some confirmation - ss panel, you can run 4d with slicks stepping up from Type SV, thus, you not having to comply with part of the following 4D based 3D rules

1. Over 6ltr

2. Traction control

3. Paddle gear shift

4. Roll Cage

5. Electronic Aero

6. Log Book

7. Window Net

8. Seats and Harness

:(

- The Tuners Group

Edited by TheTunersGroup

Looking to put an entry in this weekend for this. SO PUMPED TO be getting back to EC. Anyone know if its full?

But will need some help. Any SAU NSW folk be in attendance and able to sort me with membership and an L2S licence? My Vic membership and licence has expired whilst I have been in India?

Also, E85 in Sydney or around EC? Readily available or shoudl i best stick with an PUL tune?

...and lastly noise. I read 95 dba at 30 metres. Does that mean some external gate and titanium exhaust means i am going to have issues? The car is pretty loud, and expect even with a plumbed back exhaust it will still have some bark. So how strict are they , or how do external gate setups go at these events (normall)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...