Jump to content
SAU Community

Recommended Posts

ill have roughly 35k to buy another car. I was just wondering what your opinions are on purchasing either a 33 GTR or and 34 GTT.

i currently have a s2 r33 slighly modified. i would assume that if i but a GTR i wouldnt need to modify it, whereas buying a 34gtt would be pretty stock. plus the disadvantage of not going sideways or drifting in the gtr

Link to comment
https://www.sau.com.au/forums/topic/31522-33gtr-or-34gtt/
Share on other sites

  • Replies 65
  • Created
  • Last Reply

Top Posters In This Topic

Tough call that one. Everyones got their preferences and as far as looks are concerned that's something you've got to decide for yourself.

On "paper" both the R33 GTR and the R34 GTT put out the same power, so there's not a lot between them in the power department.

Most people are gonna say go the GTR because, well - it's a GTR! :(

With the GTR's you'll get what is considered a stronger engine, plus the ATTESSA torque split system. You'll also be getting an older car, with higher KM's and an older design. Personally I like the feel of the R34's - they seem much smaller than the R33 series, particularly inside. R34's have the more modern interior and the updated RB engines with improved torque output over earlier RB's. Handling, well my R34 handles pretty well but I've never driven an R33 GTR at speed so I can't really compare. Both cars have HICAS, LSD's, sway bars etc and both have 17inch alloys as standard.

If drifting is what you're wanting to do, then perhaps the RWD GTT would be the wiser choice.

Probably the best advice is to test drive both and see what you think! :)

Dave

Link to comment
https://www.sau.com.au/forums/topic/31522-33gtr-or-34gtt/#findComment-636377
Share on other sites

Go the GTR, GTR's hold their value, $35k will get you a good one. Youll be able to resell it for what you paid for it. Plus GTRs are the ducks guts of all cars and what all GTS, GTT etc drivers dream of.

Plus power... stock GTR eats GTT's.

Plus Grip

Plus the 11 inches of front and rear rubber (265/40/17 fit on stock wheels)

Plus watching the tail hang out at will on a skid pan and then gathering it in by pressing the loud pedal

Plus street cred as in.. "What kinda *line* ya got" "OHHH so you dont have a GTR"

(Flame proof suit on)

Link to comment
https://www.sau.com.au/forums/topic/31522-33gtr-or-34gtt/#findComment-636389
Share on other sites

^^^^^ hehe I knew you guys would say that ^^^^^

:(:)

They're right though. The GTR has the street cred and the instant respect that the GTT lacks. Re-sale is always going to be better for the GTR. The GTT is an absolutely fantastic car in every way, but the GTR is better. I'd be happy to own either.

Link to comment
https://www.sau.com.au/forums/topic/31522-33gtr-or-34gtt/#findComment-636413
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drive beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
    • Yeah good luck out there! Will be good to see a mighty GTST going harder than the GTRs
    • i will be there 😁
    • Hello!  i just finished manual swaping my r34 skyline with a r33 rb20de box(RB71C)box  When the car is running it squeaks crazy loud and it was smoking from the gearbox area. The gearbox is fine it was tested. The clutch slave cylinder seems like it doesn't fully releases the clutch. I want to ask if this noise is from the throw out bearing or could it be the clutch assembly or disk att.xFliq87Gzw6kImKBVqDebXkj0fBqymk0JaYeP3_3SlM.mp4
×
×
  • Create New...