Jump to content
SAU Community

Rb20 Anyone Know How Much Power They Can Handle

smitty 33
 Share

Recommended Posts

battery Mentor

battery

Posted
Posted
lol ok then ill try and get 205kw when i got for a tune.

yeh better to be safe.

I learned the hard way when i raced for pink slip's and fried the piston rings but it was ok cause i almost had him.

then i built a 10 second "2jz no shit" powered supra to race Ferrari's.

know i have the money and most importantly the respect!

it ain't easy but i think you can do it to.

Count Grantleyish Grand Master

Count Grantleyish

Posted
Posted

Does the VL fitted with a obligatory dose pipe when 'cruising' as shown on the picture? (yes, I'm bored)

As for power the good 'ol 20 can handle - it's relative you could have as many killerwasps you want but how long it'll last for, that is the question.

Roy Grand Master

Roy

Posted
Posted

Who knows, a guy ran a 3040 on his std Rb20 with cams in Sydney makign 280rwkws until his car had an acco. I have run 260rwkws for about 6 years and 45,000kms on a std motor (TD06-20G) Though the past two years it has not seen many kms, but still, call it 4 years and 40,000kms on a motor i got from a wrecker. And that includes plenty of track days, some drift days, some drag runs where it ran 12.9... and two Dutton Rallys. So to me that qualifies as reliable :ermm:

SimonR32 Grand Master

SimonR32

Posted
Posted
Who knows, a guy ran a 3040 on his std Rb20 with cams in Sydney makign 280rwkws until his car had an acco. I have run 260rwkws for about 6 years and 45,000kms on a std motor (TD06-20G) Though the past two years it has not seen many kms, but still, call it 4 years and 40,000kms on a motor i got from a wrecker. And that includes plenty of track days, some drift days, some drag runs where it ran 12.9... and two Dutton Rallys. So to me that qualifies as reliable :ermm:

Adam here is Perth ran close to 300rwkw for about 2 years before stretching the head studs :D

I'm hoping for at least 260rwkw and wanting more like 280rwkw, lets see how long that lasts...

funkymonkey Grand Master

funkymonkey

Posted
Posted

I'm making 208.5 awkw nice n safe on stock RB20 with an HKS 2530 strapped to it. upgraded injectors, fuel reg and fuel pump, but that's all external stuffs. It was daily driven up until last year and the setup has lasted just fine for the last 5 years.

joeyjoejoejuniorshabadoo Grand Master

joeyjoejoejuniorshabadoo

Posted
Posted
This sounds hilarious! anyone know where it is?

i found it a lil while back but most f the pic's have disapeared now anyway so it doesn't make the lulz it used to

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
    • 25zenki
      S1 rb25/s14 starting problem

      By 25zenki · Posted

      I checked spark on all cylinders and they all visually have spark with the plug pulled and grounded, but plug 1 is the only one that fouled. This was a running swap that blew up and was rebuilt by a machine shop, put a new wiring specialties harness and did all gaskets, studs, and bolts while it was out.  compression is 135-150 across all cylinders. Aside from that from my understanding with the z32 ecu and maf the car should start regardless. The wiring for TPS and the dual 02 sensor/ dual knock sensor stuff shouldn’t actually stop the car from starting or even running well, (just slightly rich)  they just give fault codes. Car supposedly is supposed to start as long as you have z32 afm and ecu with the nistune base map and that’s info coming from a well known and trusted tuner who does a lot with SR/RB (Rsenthalpy). After more trouble shooting today where I’m at right now is that the cas is sending signal to the injectors they click while spinning the rotor, Fuel pressure is now set at 43psi, all cylinders have good compression and all of the plugs looked great (just wet with fuel) except for cylinder 1 which was very black (cylinder 1 has 150psi compression). all of the coils generate spark if pulled out and grounded out on the head. On the fuel pump car just pops into the exhaust. On starting fluid car will fire off. Hard to tell if all cylinders are firing off but definitley a couple. sounds like all of them but it’s only for 3-5 seconds hard to tell. 
    • DraftySquash
      Looking for someone with a R34 front bar

      By DraftySquash · Posted

      Final update!!! Got the front bar fitted and sprayed and all sorted now. My cutouts worked great and the indicators aren’t just falling off. 😂  
    • Dose Pipe Sutututu
      new 1.5 LSD issues/concerns

      By Dose Pipe Sutututu · Posted

      Is this a brand new LSD? if so, have you followed any break/bed in procedure for it? Usually involves heaps of figure 8 patterns, a fluid flush.
    • MBS206
      Most women will agree that parking is the most taxing part of driving

      By MBS206 · Posted

      It's TWO steering wheels actually. 😛 one for each hand They are wheels, and they steer!
×
×
  • Create New...