Jump to content
SAU Community

Recommended Posts

pictures are a little close for me to tell how bad they are but id say the 1st you can buf out with a good clay and a substance like QUIXX SCRATCH REMOVER or if not to deep use Meguiar's ScratchX.

for scratch 2 you could use touch up paint from a car shop i think repco has little tubes of touch up paint like a nail polish tube for small scratches, since its down under the bumper you can use the brush from these to touch up the scratch and then once dried use a polish to buff it out and smooth it

from what i can see your paint is gloss black so a gloss black would work just dont use 2 much cus then it will seem obvious

your other option for both would be a car repair shop witch wil charge you about $600 for a full respray but take note the more you do this the more chips will look more obvious as once resanded and resprayed the new paint will chip easier, ask any panel beater and they will confirm

gibbo, try carmate.com.au for aftermarket

u may need a local shop to work on getting it to fit perfectly as i heard their kits arn't 100% flush fitment.

otherwise the yahoo japan auctions have plenty of parts

  • 2 weeks later...
your other option for both would be a car repair shop witch wil charge you about $600 for a full respray but take note the more you do this the more chips will look more obvious as once resanded and resprayed the new paint will chip easier, ask any panel beater and they will confirm

this is your best option. If they do it properly, it shouldnt chip easier.. They will need to use a fine sand paper to take the gloss off the whole bumper. Then patch the damaged parts with a tiny bit of bog or putty if necessary. Sand over the bog. Prime over the bog. Sand over the prime and then repaint the whole thing.

It shouldnt chip off easier if you pay $600 for it... Id be pissed if it did for that much.. Put it this way materials cost about $100 if that.. and its about 1 day labour.

used the quixx scratch repair....it didnt even take the lightest scratch off, completely useless

if the scratch is not to deep eg not reached the primer you can fix it using products like Quixx if its deep then you need a touch up paint pen

make sure you follow the instructions provided properly and you may even need to repeat the process a few times

found these instructions on their site :

Preparation:

Wash area to be applied to remove dirt and grease. Read instructions carefully. Test product on small concealed area first.

A. For MINOR scratches (e.g. car wash):

Apply QUIXX Finish (No. 2) to the scratched area. Polish it with a clean cotton cloth in a circular motion applying some pressure to a mirror finish.

B. For normal scratches:

Step 1: Apply QUIXX Repair Polish (No. 1) to the scratched area and polish it for about 1-2 minutes with a clean cotton cloth in a circular motion applying pressure. Remove residues with a damp cloth.

Step 2: Polish the worked areas and any matt patches with QUIXX Finish (No. 2) to a mirror finish.

C. For deep scratches (e.g. scrapes):

First wet-sand the scratched area gently with little pressure for about 10 sec. by using the enclosed special sandpaper (grain 3000) with water. CAUTION: Do not remove all paint or clear coat! Do not expose primer! Follow steps 1 and 2.

D. For extremely deep scratches (exposed primer) and stone impacts:

In this case, first use a suitable color corrective paint (touch-up paint pen)

and let it dry for about 1 week. Follow the steps in C).

WARNING: Use according to instructions! Not suitable for extremely deep scratches exposing primer. If primer is exposed, first use a suitable colour corrective paint

it all depents how deep your scratch is but

let me know how it goes btw where did you get yours from?

got it from ebay...

gave it a go... honestly i think MAYBE it helped a little bit for the big scratches but i suppose it was never gonna do much on them... the little scratch it did jack all... probably wouldn't recommend

mjay can you link me your ebay purchase page - i think i might of gotten the from the same seller ,im suspecting i got a duped one maybe fake or lesser quality if you and i got from same seller.

on another note has anyone used scrach x 2.0 from meguairs? if so thoughts and exp with it??

Edited by ezy03
mjay can you link me your ebay purchase page - i think i might of gotten the from the same seller ,im suspecting i got a duped one maybe fake or lesser quality if you and i got from same seller.

on another note has anyone used scrach x 2.0 from meguairs? if so thoughts and exp with it??

boought it off ebay seller "High_Series"

i dont think mine was fake... honestly i jus think that the product is not really effective on scratches beyond the lightest scratch... i'm getting my car detailed by dr detail this week though so i didn't put too much effort in tryna get em out... i figure if he can't then i'll just touch up paint it

  • 3 weeks later...

Hi Mjay,

Not sure if you've fixed your car scratches. Sometimes it's worth getting the experts to do the job for you. I had great results with a local Sydney Northern Beaches mobile repairer. If you live in the local area you might want to try http://www.sydneymobilepaintrepair.com.au Certainly wont try the quixx scratch repair as you said it was useless.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...