Jump to content
SAU Community

Recommended Posts

  • Replies 49
  • Created
  • Last Reply

Top Posters In This Topic

I think that you have got it all wrong. When he took his hand off the wheel he was just reaching for his harpoon. Whale season is coming up didn't you know?

Seriously though, I've had a similar thing happen to me. There was no reason for it, just felt like I was being baited. As long as you do the right thing and take down the details like you have you should be sweet. Hopefully this is the only time it happens to you otherwise you end up looking over your shoulder everytime you take the car out.

I think the people that are following you are paranoid....

Probably just some rent a cop jerk that needs a wake up call, I would report it as a "roadrage" incident.

I think that you have got it all wrong. When he took his hand off the wheel he was just reaching for his harpoon. Whale season is coming up didn't you know?

Seriously though, I've had a similar thing happen to me. There was no reason for it, just felt like I was being baited. As long as you do the right thing and take down the details like you have you should be sweet. Hopefully this is the only time it happens to you otherwise you end up looking over your shoulder everytime you take the car out.

Edited by grygtr

Troy at a police station:- "I wish to report a road rage incident officer!"

Desk Sgt:- "And what happened young man?"

Troy:-

"Well (gulp), it's like this...

As I exited the roundabout at rose cottage, this guy swerved violently out of the left lane (without indicating) to race up behind me like any typical wanker would do in his Holden, then proceed to sit close enough on my ass that I can no longer see his headlights in my rear view mirror. I don't accelerate any further as there's already a car in front of me, and it would be speeding. This guy then leans over to the passenger's side of his car, apparently reaching for something as he both removed his hand from the steering wheel, and focused on looking for whatever he was instead of the road - in particular the car he was no more than 2m away from - me. He then appears to be taking note of my license plate. Hmm. A few roundabouts later when he's not on my ass so much, I decide to see if he's following me by turning left. He doesn't follow me, but instead passes me while again removing his hand from the wheel and attention from the road, leans over the passenger's side to either give me the finger or point at me threateningly."

Desk Sgt:- "And can you describe what that bad man looked like?"

Troy:- "Like YOU!"

:D

The police can, or anyone can? That's outrageous, and would net him a complain...with any luck more than a slap on the wrist given his driving at the time of the incident.

Oh wow. Well now I know one way to seek revenge and make myself feel better if this goes anywhere. Those bombadore driving scrubs better watch it - no I don't want to race your soon-to-be defected shitheap.

Its not as bad as NSW where you can have your car impounded for 3 months if someone just rings up as says you were doing burnouts.

Happened to a few mates of mine after they had a blue with some neighbors

Its not as bad as NSW where you can have your car impounded for 3 months if someone just rings up as says you were doing burnouts.

Happened to a few mates of mine after they had a blue with some neighbors

I'm pretty sure they can do that here too... unless the guy I was speaking to was in Queanbeyan.

Terry, I know you're a pharmacist so I jokingly assumed that you would have access to all kinds of weird and wonderful chemicals.

I now know this to be true.

What on earth did that mean? lol

just curious.... if you have to suddenly brake for whatever reason, and the police car slams to back of yours( because he's tailgating) will he be at 100% fault or can they say braking suddenly = dangerous driving.

my understanding is if I hit someone from the back, it is my fault no matter what.

Exactly. If you hit the brakes for no reason, I'd say you'll still get hit for dangerous driving or negligence, but they're still 100% at fault.

Unless they're even further above the law than first thought.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeah, this is one of the most annoying things about nissan part numbers... I've got an unrelated example... Image is of the AT output shaft ~ they have the same part#, but clearly the shaft on the left is beefier design to that on the right ...the difference (essentially) is the 'lighter' shaft on the right, is for engines up to RB25DE (this includes RB20 variants) : the shaft on the left is for RB25/26DET(T)....are they interchangeable? Yes...but obviously one shaft is going to be stronger than the other...and, the lighter shaft is around USD115, but the heavier shaft closer to USD150...same part#... ...epc-data usually tells a tale ~ the amayama listing for 39100-23U60 has a note "Longest side is between 60 and 105 cm" ; no such info is there for 39100-23U70 ...and given the great disparity in price between the 2 parts, it makes me at least curious (to the point of caution) where the 'extra money' went? ...ie; these 2 parts have a cost difference that (to myself at least) isn't explained by 'plastic boot'...ie; with amayama there's AUD700 price difference ...plastic versus rubber?...I'm not seeing it like that...and 60cm ~ 105cm...??...that's a huge disparity....something hinky going on here... I'd try searching by VIN, not model... /2cents
    • I don't know for sure, but I'd expect them all to be interchangeable given the diff end and hub end don't move/change between any C34 series. Often Nissan will change part numbers and the aftermarket follows those year ranges; but the original part number change doesn't mean other parts won't fit. The change could be a change in material, internal parts or even just supplier. For example, all the RB gearbox to engine bolts are no longer available and there is a new part number instead. The only change is they went from cadmium plated bolts to zinc plated due to the issues manufacturing with Cadmium. They look different but work the same.
    • One year is a bit concerning. Did you try contacting GSP? It says 5 year warranty on the box if I remember correctly. I'm also running their driveshafts on my S2 Stagea.   You could check the part numbers on Amayama for your year. Here's the link for my 1998 which gives the 39100-23U60 part number. Well, that and 39100-23U70. https://www.amayama.com/en/genuine-catalogs/epc/nissan-japan/stagea/wgnc34/6649-rb25det/trans/391 What does it say for yours?
    • I ordered a GSP Front R/H Axle from here - https://justjap.com/products/gsp-premium-front-driveshaft-r-h-nissan-r32-r33-r34-skyline-gtr-stagea-4wd#description It lasted around a year before one of the boots blew out. I'm lowered, but I have GKTech roll center adjusters. One year seems a little premature. I think I'm going to spend the extra money on an OEM cv axle this time. This website - https://tfaspeed.com/collections/nissan-stagea-wgnc34-x-four-parts/products/nissan-stagea-awc34-260rs-rb26-right-front-axle-drive-assembly Makes it sound like the readily available OEM CV axle will only fit 11.1999 Stagea and up (mine is a 2.1997 S1). The JustJap listing didn't mention any years or anything for the GSP axle. Amayama shows '11.1999' and up as well for that part number. As well as 'plastic boot type'. See attached picture. So I guess my question is, does that axle (39100-23U60) really only fit S2 Stagea? It's the front driver side. If it does, I'd love to buy that instead of rolling the dice on another GSP. I've found that OEM one cheaper here: https://www.partsfornissans.com/oem-parts/nismo-jdm-r32-r33-r34-skyline-gtr-r32-gts4-right-front-axle-3910023u60 and here https://www.nissanparts.cc/oem-parts/nismo-shaft-ft-drive-3910023u60 Just a little confused because the JapSpeed listing for the GSP front driver axle doesn't mention any specific years or anything and it fit my S1 Stagea fine. So will 39100-23U60 fit my S1 Stagea even though technically it says '11.1999' and up? What would have changed? Thanks.  
    • Thanks for the info. The only "Issue" I've had with the shifter is I always found the throw between 4th and 6th gear too close. I'm always worried to shift into 4th accidently and sending my motor to the moon. Adam LZ recently came out with a video and stated Serialnine revised their shifters to correct this and will change all the revised parts for 150$. Strangely enough, I contacted Serialnine right after and they denied it and said it's bullshit. I found that strange as he's a distributer. I'll keep this forum post updated on that saga.
×
×
  • Create New...