Jump to content
SAU Community

Recommended Posts

http://www.skylinesa...5890781__st__20

almost 1000rpm of spool difference, although completely different dyno setups so not really that compareable. Still it really does look like his is set up perfectly.

He is also using external gate and manifold, what are you using?

Internal gat and no manifold. I get full boost by about 4k on Trent's dyno. Forget the other chart. Ill post up Trent's one asap.

Gives me hopes to see the gtx spool faster than gt. Means ill have same/more top end with better spool.

Edited by ShiftyTys

4K actually sounds around about what I would have expected for that setup, thats not too bad.

Trent recons a bit of a fiddle n we can knock 500 Ish off. And give me another 20+ throughout midrange.

this is probably stupid but could t be the standard intercooler piping is also choking it..its only 60mm tube and that turbo is trying to push a large volume of air..also dont know what cat its running..still seems to me like its just choking up...im not convinced its just tune related :unsure:

this is probably stupid but could t be the standard intercooler piping is also choking it..its only 60mm tube and that turbo is trying to push a large volume of air..also dont know what cat its running..still seems to me like its just choking up...im not convinced its just tune related :unsure:

Quite possibly but Trent recons mainly actuator based. I'm sure he would mention if it seemed to be choking at the cat or cooler. 3" highflowed cat.

Trent recons a bit of a fiddle n we can knock 500 Ish off. And give me another 20+ throughout midrange.

Well he's got the advantage of having had it on his dyno and seeing where the potential is so thats pretty promising, I guess if VCT isn't (but can be) enabled there's definitely gains to be had just there. Sounds quite promising, and basically means GTX3076Rs will be full boost at ~3500rpm on RB25s which is pretty sweet.

Get rid of the cat.

How many people here that run this turbo are actually using a cat? or can say they have seen this turbo on a car with a cat? and are making a fair comparison on the response side of things. No cat will make a big difference

Edited by ido09s

id be getting a 80mm hotpipe and at least 70mm cold pipe made up as well.. PM scottynm35 hes near dandenong and will make that up for you.. He can probably gut your cat as well..

And get all this done before it goes to avo Monday week?

id be getting a 80mm hotpipe and at least 70mm cold pipe made up as well.. PM scottynm35 hes near dandenong and will make that up for you.. He can probably gut your cat as well..

And get all this done before it goes to avo Monday week?

its a 3 inch cat on a 600hp capable turbo, of course its a restriction..

infact his whole setup is a restriction ....no offense shifty ;)

No.its not. Lol. At 600hp yes. But 3" Turbo Back is enough at this power surely The cat Is highflowed to 3" too. So id assume thats ok. I have 4" intake. That's fine. What else is.there?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...