Jump to content
SAU Community

Recommended Posts

A creek runs under our carpark at work and with the massive downpour this afternoon it burst a huge 3m hole in the ground and flooded the carpark and surrounding offices and buildings, lots and lots of damage done, few cars were completely ruined and no longer start, the sports stadium was filled completely with water. We are on a bloody hill as well, I couldn't even understand how the water managed to pool there, there was just so much that it couldn't drain down the side streets fast enough.

Anyway my car was under about 40cm of water, seals in the doors stopped it coming in but it must have leaked through a few holes in the floor. Exhaust (big 3" one) was completely filled as well.

Muffler no longer does any muffling as the water must have collapsed the baffles or something but it isn't too bad, sounds nicer imo just loud (its a skyline), I jacked it up on a slope and got most of it out then just drove it for an hour to boil the rest out, no more steam but the muffler is still loud, is it likely its never going to quiten down again?

Also with the floors when I got in everything was dry but over the hour the water soaked through the carpets, peeled them back and they are pretty much soaked through, left some towels on the floor to soak as much up as possible but I think it will be a carpet out job.

Its going to be raining for ages to come so I probably wont be able to get them out until the weekend, what should I do? buy some anti mould powder and leave the carpets to dry in the sun for a few days? Or is it guaranteed to smell no matter what I do?

Also is the council liable for this as it was entirely due to the creek bursting through and not just bad rains, every building in the carpark had their lower floors flooded and quite a few cars were badly damaged. I don't mind pulling it all out and cleaning it up, but I cbf buying new carpets and a muffler if I have to.

http://www.adelaiden...67109078?page=3

some pictures of some unlucky people.

Also oil contamination, I am going to do the engine oil this weekend, but what are the chances that the gearbox and engine oil have water in them now? don't want to flog out my motor driving it the next few days until I get the chance to fix it.

Edited by Rolls

had a mate get his ute stuck in a river for an hour and few days later heaps or plugs had green death in them and corroded out. i would hit any plugs that woulda been under with silicone spray, crc or wd-40 etc just to be safe. 40cm should be well below the dipstick?

unlucky mate

Yeah more worried about the breather/filler pipe on the trans and diff, are they bunged up or are they open?

Just removed the entire interior bar one bolt holding the carpet in and it started pissing down again, luckily there is only a single loom of 24 wires (I think) that was wet, shouldn't have to replace anything else.

still f**king gay though, what retarded council routes a river under a carpark.

Also amazing timing I just sold my spare car LAST NIGHT, f**k I wish he didn't turn up.

Edited by Rolls

Hahaha the council didnt put a river under a car park. The building was built over it. If there is a 3m hole in the concrete floor thats a dodgy building. I would be concerned how they built the reat of it.

Easiest way to dry out your car would be to put a portable dehumidifier inside and leave it running. We have a Delonghi dehumidifier that pulls 20 litres of water out of the air each day, so it would do a pretty good job at drying out your car.

I wouldn't be too concerned about water in your engine/gearbox/diff oil. Though if you can't sleep at night because of it, you will only have to drain a little bit of oil from each to confirm whether there's water in there, as it is heavier than oil it will pool at the bottom.

  • 4 weeks later...

Hahaha the council didnt put a river under a car park. The building was built over it. If there is a 3m hole in the concrete floor thats a dodgy building. I would be concerned how they built the reat of it.

wasn't the buiding it was the carpark.

img0265i.th.jpg

imgp2334.th.jpg

Edited by Rolls

you can't blame the council for floods like this

Have a look at the video link...I'm sure that could be blamed on the council. It's not the flood that caused it per se, it's the fact the water was flowing under the surface of a carpark

Don't you have insurance?

They would pay for the lot - Or even write the car off and pay you out.

Buy back the repairable write off and fix it = easy profit.

You really shouldn't be buying a car like this if you can't afford insurance?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok I get you. But isn’t the butterfly intake a headache with the +T?  see this is my plan so far but please advise me into the right direction.  Nistune Ecu, 1000cc Bosch injectors, TD05 or TD06 Kinugawa turbo using stock rb25det exhuast manifold, walbro fuel pump unsure of model I think it’s 450/460, spitfire coils and sparks to suit and a R35 MAF sensor and boost sensor.    I was thinking maybe do a cheap eBay plenum $400-500 or try find a stock det neo intake. I think I’d port match it so it’s getting the full capacity but open to advice please.  Thanks 
    • The issue now is the 'fuel cut' while driving, and when it happend, it does not stall. This, I did not test the fuel pressure while driving as I cannot with a fuel pressure gauge. I do have Nistune logs, yes. I have also replaced the MAF Sensor.   Also related to the FPG Fuel Hanger – I just realized that I need a Deutsch Crimp Tool to crimp some cables for the FPG Fuel Hanger. Need to purchase additional cables as the kit only included 2, which are for the float. FPG has not responded to my emails so far since purchasing. I thought about taking it to someone and having it done professionally, but I am reluctant since everyone I took it to messed up in some way.  
    • There's a good German place in Brisbane if youre up for the drive 😛
    • The German place in Cabramatta was rock solid, fresh pretzel cooked to order back then. Then it went all quiet, after all the poker machines were removed, then I believe it closed for good. I did drive past the other week and noticed outdoor lighting a big screen, but no idea what is there now.  
    • Yeah I suspect even if you hold airmass per cycle/cylinder constant if you get too far away from stock you're still going to have problems running the factory tune within the bounds of the factory load scale. Cams, different displacement/rod ratio, etc. I'm just lucky that the GTIII-SS with wastegate boost + CA compliance cats is pretty much equivalent to stock turbos. When I have actual space I can finally get it tuned and modify the fuel system for flex fuel to 100% handle any detonation concerns when cranking the boost to whatever those dinky turbos can put out.
×
×
  • Create New...