Jump to content
SAU Community

Recommended Posts

  • Replies 95
  • Created
  • Last Reply

Top Posters In This Topic

I've corner weighed plenty of skylines.

Every one of them varies but on average an r33 gtst's come in around 58%front heavy

R33 GTR's are typically 62-65% front heavy.

Comparably a 32 gtst is 56-60% front and a GTR 58-62%.

Most of the cars I've done vary in trim level, cages, body mods etc so it's pretty hard to get an accurate average.

Cheers for that :)

So going off that 58%, say a R33 GTST weighed 1400kg, it would take moving around 112kg from the front to the rear of the vehicle to get close to a 50/50 weight distribution.

Or removing 224kg from the front to get close to a 50/50 weight distribution.

Or obviously a mixture of moving and removing.

Crazy. Makes you really see how front heavy they are.

I've corner weighed plenty of skylines.

Every one of them varies but on average an r33 gtst's come in around 58%front heavy

R33 GTR's are typically 62-65% front heavy.

Comparably a 32 gtst is 56-60% front and a GTR 58-62%.

Most of the cars I've done vary in trim level, cages, body mods etc so it's pretty hard to get an accurate average.

Fairly standard R33 GTR Vspec

FR: 430kg

FL: 447kg

RR: 360.5kg

RL: 331kg

Total 1568.5kg

Cheers for that :)

So going off that 58%, say a R33 GTST weighed 1400kg, it would take moving around 112kg from the front to the rear of the vehicle to get close to a 50/50 weight distribution.

Or removing 224kg from the front to get close to a 50/50 weight distribution.

Or obviously a mixture of moving and removing.

Crazy. Makes you really see how front heavy they are.

Remounting stuff goes a long way to helping without actually removing that much weight from the car.

Moving weight around on a set if good scales has the greatest benifit.

Typically if building a car from scatch it will permanently be sitting on scales.

I have been doing an s15 recently which has always been on the scales so things can be located once and properly.

The height various components are mounted is just as important as their location if your worried about a front to rear center of gravity height and roll axis as well.

Corner weighting via ride heights with a purpose built race car should be done after the car is statically balanced with weight.

Just for your info my r33 gtst stripped out and caged weighed in at 1374kg on the scales at EC. That is with a full tank of fuel and all factory body panels. I am very keen to get it down to the mid 1200's.

Moving weight around on a set if good scales has the greatest benifit.

Typically if building a car from scatch it will permanently be sitting on scales.

I have been doing an s15 recently which has always been on the scales so things can be located once and properly.

The height various components are mounted is just as important as their location if your worried about a front to rear center of gravity height and roll axis as well.

Corner weighting via ride heights with a purpose built race car should be done after the car is statically balanced with weight.

:thumbsup:

Mike was your car weighed with driver and full fluids?

Just curious

Full fluids with 3/4 tank of fuel. No driver... would have been a lot worse we me in the driver seat, you have seen the state of me Brad, lol. I think if you could get at least 100-150kg of weight out of the R33 GTR in the front half of it it would make a lot of difference.

Good to chat with you Fineline, cheers mate.

  • 1 month later...

Just put mine on a set of corner weights. Striped interior and of stock loom. Driftek 17/9.5 GTR off with 235/45 Kumho V70A glass bonnet all other pannels std (Drivers door has no insides at all though) And 1/2 tank of fuel.

Cross 613kg 50.3%

Left 613 kg 50.3%

rear 511 kg 41.9%

LF 353kg RF 353kg

LR 260kg RR 251kg

Total 1217

I need to re do it with me in it yet, but is a starting Point.

I have 10kg to come out of the pas door and a set of light kevlar Guards to go on..... looking for 1280 full of fuel and with me on board.

Edited by Noddy

I am also trying to put my car through the Jenny Craig program and this threads been great but this will be a silly question to most of you but where would I go to weigh my car? lol How much will it cost?

Also would taking out the side rear air bags be illegal for a road registered car?

Edited by Bourbon Boy

Taking out any factory airbags is illegal in most states (most likely all). Also as far as I am aware, disconnecting just one airbag in a vehicle with multiple airbags makes the rest not work.

Any good workshop that sets up race cars should have calibrated corner weight scales.

If you just want an overall weight a public weigh bridge will do. I took my truck over one today was $22.00

If your in Sydney and want to know individual weights I can help you with that.

weight your car at a garbage tip for free, if you are near a tip that uses weight to charge for rubbish, drive in turn around and come out...no weight change no cost... lol...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
×
×
  • Create New...