Jump to content
SAU Community

Will 800Cc Inj On Rb26 Be Big Enough For E85

Mark-32

By Mark-32,
in Engines & Forced Induction

 Share

Recommended Posts

  • Replies 74
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Popular Days

The Dan Grand Master

The Dan

Posted
Posted

I'm now seeing 620 rwhp on E85 with CDI ignition allowing/accepting much more fuel. This is despite my modererate 2860-5 low mount turbo setup. My HKS 1000 CC injectors are at full duty cycle at max torque.

In hindsight, I would have gone to ID2000 (2000cc) injectors as the HKS units weren't "plug and play" in any case.

I'll take the opportunity again to express how impressed I am with the billet.net.au CDI kit (M&W CDI + bracket + harness etc). The spark strength allows bullsh*t amounts of E85 fueling midrange and just wakes up the turbo response. Forget your Splitfire/Twinpower combo.

We usually go LS2 Truck coils on anything that needs more spark. They have 120mj output as opposed to LS1 coils with 60mj ouput

CDI is good though, it does have its limitations in some applications and can cause extreme noise in street cars if not properly wired or shielded

O2 Autosports Enthusiast

O2 Autosports

Posted
Posted

I'm now seeing 620 rwhp on E85 with CDI ignition allowing/accepting much more fuel. This is despite my modererate 2860-5 low mount turbo setup. My HKS 1000 CC injectors are at full duty cycle at max torque.

In hindsight, I would have gone to ID2000 (2000cc) injectors as the HKS units weren't "plug and play" in any case.

I'll take the opportunity again to express how impressed I am with the billet.net.au CDI kit (M&W CDI + bracket + harness etc). The spark strength allows bullsh*t amounts of E85 fueling midrange and just wakes up the turbo response. Forget your Splitfire/Twinpower combo.

how much is the m&w setup worth?

I maxed my 900cc injectors@65psi fuel pressure out at 420kw/560hp. should have just put id 2000's in in the first place.

rob82 Mentor

rob82

Posted
Posted

You trolling me or are you just clueless?

Calculated fuel flow based on the EXACT ms open time of the injector at peak power. The injectors are being told to deliver that exact amount of fuel. So where to get one? windows has a calculator or you can buy one from any newsagent

Well if you've already calculated the fuel flow then surely you must know the duty!

PS - assuming base pressure of 3Bar I'm guessing your close to 100% duty.

GTScotT Grand Master

GTScotT

Posted
Posted

Well if you've already calculated the fuel flow then surely you must know the duty!

Im sure its simply a case of he remembers the flow rate more than he does the duty. Big deal...

The Dan Grand Master

The Dan

Posted
Posted

Im sure its simply a case of he remembers the flow rate more than he does the duty. Big deal...

Exactly right.....and if he read my post again he would see what I wrote in brackets instead of beng as quick as possible to jump on my post

Beer Baron Grand Master

Beer Baron

Posted
Posted

I'm now seeing 620 rwhp on E85 with CDI ignition allowing/accepting much more fuel. This is despite my modererate 2860-5 low mount turbo setup. My HKS 1000 CC injectors are at full duty cycle at max torque.

In hindsight, I would have gone to ID2000 (2000cc) injectors as the HKS units weren't "plug and play" in any case.

I'll take the opportunity again to express how impressed I am with the billet.net.au CDI kit (M&W CDI + bracket + harness etc). The spark strength allows bullsh*t amounts of E85 fueling midrange and just wakes up the turbo response. Forget your Splitfire/Twinpower combo.

hey gav, very interested to hear about this M+W CDI kit. what coils are you using with it? rough ballpark on cost? and also what ecu are you using?

thanks mate.

R

GTS-t VSPEC Grand Master

GTS-t VSPEC

Posted
Posted

Kit Consists of the following:

1. M&W Pro-16B or Pro-Drag 6 CDI Ignition Amplifier

2. 6 x CDI Pencil Coils

3. Complete Shielded & Terminated wiring harness using military spec wiring

4. Coil Adaptor Kit

5. 6 x Denso Iridium Spark Plugs

From what I remember speaking to Gav about it a couple weeks ago, cost is around $2.5k, which almost made me faint. Getting my car tuned with E85 soon, will see how far the 850cc injectors get me, hoping for 500rwhp.

GTS-t VSPEC Grand Master

GTS-t VSPEC

Posted
Posted

Guess you'd hope it would be better than a HKS DLi... Given its almost 3x the price!

Given that Xspeed are the HKS Distributor, and even they were impressed with the results, I'd say it is better. Worth the price? I'm not so sure.

This is a kit after all, and is primariliy made from off the shelf M&W and AEM parts, just with a custom billet mounting plate and some custom wiring. You could probably make something up yourself of alot cheaper. Between the amp and the CDI coils there are $1500US worth of parts.

SimonR32 Grand Master

SimonR32

Posted
Posted

I have done a search but cant find a definate answer....Engine is rb26dett.

If using twin 044's, with twin entry rail etc, will 800cc injectors be ok if i just bump up the rail pressure, and If so to what power level?

My 800s are pretty much brand new sards so If I could keep them instead of having to buy new ones that would obviously be the go.

Any help is much appreciated. Cheers

370-380rwkw would be my guess, which is confirmed with T04GTR's results and GTRgav's and pretty much every other result I have seen :)

A fair whack more than 300rwkw :thumbsup:

The Dan Grand Master

The Dan

Posted
Posted

370-380rwkw would be my guess, which is confirmed with T04GTR's results and GTRgav's and pretty much every other result I have seen :)

A fair whack more than 300rwkw :thumbsup:

Are you referring to the same T04GTR and Gav that posted in this thread? Because I'm pretty sure they said they have 1000cc injectors :thumbsup:

Beer Baron Grand Master

Beer Baron

Posted
Posted

ok, well it's not too bad. the coil pack mount is very nice and for a good CDI system and coils it's not out of this world expensive. I mean if you had to buy a set of new splitfires and a HKS DLI that's over $1000 just for a slightly enhanced factory system.

GTS-t VSPEC Grand Master

GTS-t VSPEC

Posted
Posted

ok, well it's not too bad. the coil pack mount is very nice and for a good CDI system and coils it's not out of this world expensive. I mean if you had to buy a set of new splitfires and a HKS DLI that's over $1000 just for a slightly enhanced factory system.

And from what Gav has told me they've seen a hugh improvement of mid-range, as they've been able to increase the spark plug gap. If I see a similar issue with spark breakdown when I tune on the E85 then I won't hesitate, and will go straight for these :thumbsup:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • jez NF
      The Evolution Of "night Fury"

      By jez NF · Posted

      att.4QNbuJlz_gNZPFBGFqeEvxSUHXkGt7z40V59MrtXTPg.mp4    
    • Keeper
      SAUNSW - World Time Attack Challenge - 5 & 6 September

      By Keeper · Posted

      Plan on the day will be to park trackside. Depending on space availability we will try put a small shade tent and a few of the cars on top of the hill inside turn 3, this is an easy to get to parking area with views of Turn 2, Turn 3, Turn 4 and Turn 5 and limited other pieces of the view around the track. IMPORTANT NOTE! One consideration from previous years is from memory the trackside parking sells out before the admission tickets, for that reason I encourage anyone planning on coming to buy tickets for parking now via the official website; https://www.worldtimeattack.com/ The type of parking you are looking for is 2 Day Park & View (Access Around Venue) Vehicle Pass Only Please note this does not include admission to the event itself, remember to grab that also, and kids under 12 get in for free!
    • Keeper
      Mid week Palm Beach Cruise

      By Keeper · Posted

      This is going to be a mid week evening cruise. Come along and join us for a drive out to Palm Beach. This is a change of event plans after talking to some of the older members of the club. SAU NSW is planning on hitting Old Pac again shortly, stay tuned for details. When: Thursday 26th of June Time: 7:30pm meet/8:00pm departure/10:00pm finish Meet: Spit West Car Park / Spit Rd Mosman NSW 2088 Destination: Palm Beach Public Parking / 16 Ocean Rd Palm Beach NSW 2108 Up to date information as always can be found on the events page of our website, the link for this event is https://www.saunsw.com.au/events/palm-beach-cruise There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our track days. This is an official SAUNSW event and will be run under a Motorsport Australia permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU:NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave. Thanks guys and hope to see you there!
    • niZmO_Man
      Rusty roof repair

      By niZmO_Man · Posted

      Good time for a carbon roof  
    • GTSBoy
      r34 Skyline 25 Gt four GTR conversion (ENR34)

      By GTSBoy · Posted

      Not in any way aroused by any of those, except maybe the big AMGs. And that would break my never a Euro, ever, rule.
×
×
  • Create New...