Bw Airworks Turbos

[GTR_JOEY]

When his surge tank is ready. Will be soon

When is he building a gearbox? About 6.7 kms after he gets it back

Bahaha smart ass

Will be a good 6.7km

[Piggaz]

Bahaha smart ass

Will be a good 6.7km

Can fit atleast 16 launches in that

[Nee-san]

And you were using the S300SX Joey ?

[GTR_JOEY]

Yep 83/75!

[Nee-san]

How does she drive around town ?

[GTR_JOEY]

Not too bad actually, a little bit laggy but thats what you would expect from a turbo that will potentially make 450kw+

I'm also using a link g4 which makes the car very nice to drive, especially on light throttle.

Will hopefully have a dyno graph to post in the next couple of months

[Nee-san]

I'm going to use a haltech, are you on E85 ?

[GTR_JOEY]

Not yet, but there will be an e flex tune as well...

What turbo you looking at, EFR?

[Nee-san]

EFR 8375, s300SX, s366SX the S300 FMW also looking closely at some of the precision turbos, 6266 or 6466 I think, all up in the air ATM.

[t04z]

finally got my s362 fmw delivered the other day so hopefully ill have run in results in a few weeks then a full tune after that

[--Redwork--]

My project has been binned.

So selling my Brand new s300 FMW (billet 8375) turbo. .91 divided t4... If anyone is intrested.

Asking what it cost me $1400.

Located brisbane.

0416 434 691.

[bigmikespec]

EFR 8375, s300SX, s366SX the S300 FMW also looking closely at some of the precision turbos, 6266 or 6466 I think, all up in the air ATM.

Ended up ordering the S366 with 0.91 divided rear end... need to wait a while to get the 1.00 A/R but should be able to do a back to back measuring exhaust manifold back pressure!

[Lithium]

finally got my s362 fmw delivered the other day so hopefully ill have run in results in a few weeks then a full tune after that

How did this go??

[SimonR32]

I was so close to getting a S300SX FMW but bailed at the last minute in favour of a 6262.

Mainly because of the lack of results for the FMW and Joey's not sounding like it has the best boost response.

[Lithium]

Fair enough, will be interesting to see how the 6262 is as there (like the S300) seem to be mixed results for them too in terms of response.

[GTR_JOEY]

I was so close to getting a S300SX FMW but bailed at the last minute in favour of a 6262.

Mainly because of the lack of results for the FMW and Joey's not sounding like it has the best boost response.

Should have some results in the next week or two

[SimonR32]

I can always swap if yours goes the right way Joey haha

[nik.]

any updates? looking for a dyno sheet here..

or do you have a thread joey?

[GTR_JOEY]

http://www.skylinesaustralia.com/forums/topic/414766-gtr-joeys-r32-gtr-e-flex-twinscroll-8375-results/

Thread here mate

[Nee-san]

Ended up ordering the S366 with 0.91 divided rear end... need to wait a while to get the 1.00 A/R but should be able to do a back to back measuring exhaust manifold back pressure!

Did you get around to measuring this Mike ?