Jump to content
SAU Community

Recommended Posts

Hear and see a old Commo wagon tearing it up past my house, tyre screeching and all and I think wtf.

5 secs later an undercover cover rips past giving chase.

Fcking A lol.

Commodore driver ain't stopping either.

Sounds very exciting over your place.

Had the perfect view as well. House being a corner block seeing them drifto around the corner.

I cant hear no heli.

You in Springvale atm? They were heading in that direction. Car decided to turn down the small streets instead of exiting at Springvale Road.

You enjoyed the action?

Made my night.

Commo driver needed new tyres though. Was still wheelspinning 15m from corner exit. Just sayin.

Im near bunnings atm. hahahaha.

lol at nick.

You spend so much time over the South-east you may as well move over this end. Do da right fing.

interesting leigh!

the car was running 118's @ full weight, anyone know enough about boring/pointless/homo drag racing to derive a rwkw figure from that?

FWIW i ran consistent 119's with 325rwkw @ 1350kg

Different power delivery would mean different MPH, F6s same weight and run much higher MPH for a similar time. There's a lot of discussion about the low MPH on the ford forums. Still sounds like the only way to prove actual rwkw would be a SAU dyno day lol care for a wager? :P

Made my night.

Commo driver needed new tyres though. Was still wheelspinning 15m from corner exit. Just sayin.

Doubt he/she'll have the coin to purchase new tyres once the po-po got a hold of him/her.

RWD - 509bhp & 1850kg

Power to Weight:280 bhp/ton

0-60:4.5

0-100:9.5

60-100:5.0

1/4 Mile ET:12.36

1/4 Mile Terminal:118

Dragstrip 1/4 Mile ET:12.16

Dragstrip 1/4 Mile Terminal:122

Calculation for the FPV GT on that vid is @ the 380rkw mark

RWD - 435bhp & 1350kg

Power to Weight:327 bhp/ton

0-60:4.1

0-100:8.6

60-100:4.5

1/4 Mile ET:12.08

1/4 Mile Terminal:118

Dragstrip 1/4 Mile ET:11.88

Dragstrip 1/4 Mile Terminal:122

Hamish ur car stats, Give or take up to .3-.4 on the quarter @ those speeds for certain tracks dependant on how much above sea level.

these calculations are not gospel but approx

This also doesn't take into consideration diff gears, torque etc obviously.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
×
×
  • Create New...