Jump to content
SAU Community

Import Monster Sauvic Deca Motorkhana - 2012 Round 1


Recommended Posts

  • Replies 378
  • Created
  • Last Reply

Top Posters In This Topic

I have been up a couple to spectate and take photos. I always loved the skids at the end. What's the go with that? Anyone get to go out as long as there is enough time?

well when everyone has had there goes at the battles and theres no scheduled events left then people get free runs on the pan doing the last battle layout. well ment to anyways

last time i went out and did 2nd gear douies for about a minute and no one got any footage of it at all :down:

but yeah as long as your not out there for too long then its alright, but this is all at the end off the day after everything is done and dusted :thumbsup:

but you do have to be a registered driver

last time i went out and did 2nd gear douies for about a minute and no one got any footage of it at all :down:

If i remember rightly you didnt tell anyone you were going out!

Dont be a sook and just do it again :D

If i remember rightly you didnt tell anyone you were going out!

Dont be a sook and just do it again :D

well i didnt tell anyone i was going to do it yes, but i thought someone would at least have a camera out still :P

Guest
This topic is now closed to further replies.



  • Latest Posts

    • If your tuner can't make the car idle like factory, I'd get a new tuner. These injectors are fantastic and I'd have very serious concerns about a tuners skill set if they couldn't get them to idle well. 
    • It's highly likely you will find something. Alternatively, a quick design and order online from chaina and you'll have a perfect solution
    • Idle Lambda target is off by .4 but I reckon the VE table is not correct. If my tuner has no issue using these injectors I will keep them, they are good quality after all
    • I already have an Apexi. Just wondering if it is worth putting in something new since the Apexi is likely well over 10 years old, if not 15. I know the injectors work but they already run at less than rated fuel pressure to make them work properly and idle is basically 1% duty cycle or less. Could be better
    • Nice, I would never have thought in that direction. The actual motor is a cylinder....I wonder if there are any cylindrical heat sinks with the right ID  (and if there is clearance to other components). I think adding airflow is still a thing as well....will check it all out next time it is in the air. Wish I had a hoist...
×
×
  • Create New...