Jump to content
SAU Community

Recommended Posts

Get a dump that fits properly,

I got a cheap one that required heaps of modifying to fit and it ended up costing as much as a good one,

And i spent heaps of time on it.

Make sure if you get a split dump, the small pipe clears everything, O2 sensor in the right spot.

the clearance under the floor, mine was too short.

What a nightmare.

explain in further detail? Please..

It's pretty obvious. RB20 is short 500cc of capacity compared to the 25, so it is harder to make the power straight up (more boost obviously needed). Then, on top of that, they run out of injector capacity and the AFM goes to 5v well below 200 rwkW.

It's pretty obvious. RB20 is short 500cc of capacity compared to the 25, so it is harder to make the power straight up (more boost obviously needed). Then, on top of that, they run out of injector capacity and the AFM goes to 5v well below 200 rwkW.

Yeah,I'm with it.

obviously needing injectors and z32.

I never thought they make ~200 with just a turbo slapped on.

My 2 cents

My 32 with rb25 turbo 14 psi that drops to 12psi after 6000rpm, blitz fmic adj cam gears nistune Walbro pump 3" split dump 3"cat 3.5" cat back exhaust manual made 160 rwkw

Mind u I made the same power with half the boost (14psi stock turbo 7 psi rb25) which was 140rwkw

My 2 cents

My 32 with rb25 turbo 14 psi that drops to 12psi after 6000rpm, blitz fmic adj cam gears nistune Walbro pump 3" split dump 3"cat 3.5" cat back exhaust manual made 160 rwkw

Mind u I made the same power with half the boost (14psi stock turbo 7 psi rb25) which was 140rwkw

My 2 cents

My 32 with rb25 turbo 14 psi that drops to 12psi after 6000rpm, blitz fmic adj cam gears nistune Walbro pump 3" split dump 3"cat 3.5" cat back exhaust manual made 160 rwkw

Mind u I made the same power with half the boost (14psi stock turbo 7 psi rb25) which was 140rwkw

stock 25 turbo simply does not flow more than 200rwkw on a 25 (with a realistic dyno operator) and for an engine that is 25% smaller i'd say there is next to no chance

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...