Jump to content
SAU Community

Recommended Posts

bench_press.jpg

Having discussed it with my pullup rival John (SRS13), our challenge for the month of March will be a bodyweight bench press. Rules are simple:

- Flat bench press using barbell

- Any width/grip

- Any leg/feet position

- Any back position (arched or flat)

- Bar must visibly touch chest (controlled, no bouncing)

- Arms must be straight at the top of each rep

- No pausing (keep the bar moving)

- No assistance (unrack and re-rack yourself - if your spotter intervenes at any point, that rep will not count)

This is bodyweight for reps, meaning if you weigh 80kg, then you will press a 20kg bar with 30kg each side. Round your weight to the nearest 2.5kg (up or down). Should my ex or current girlfriend wish to compete, half bodyweight for reps will be the ratio.

Everyone does bench press, so no vid means you're lazy, injured or a PTC competitor. You have until the end of March, but let's get some vids up early so we can post improvements along the way. I'll chuck one up on Monday :)

Press!

Link to comment
https://www.sau.com.au/forums/topic/420938-march-challenge-bench-press/
Share on other sites

  • Replies 214
  • Created
  • Last Reply

Top Posters In This Topic

Rules updated with no pausing and rounding your body weight up/down to the nearest 2.5kg. When posting vids, state your bodyweight, weight lifted and total reps.

Leigh, you will be doing this :)

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...