Jump to content
SAU Community

Recommended Posts

http://m.youtube.com/#/watch?feature=youtube_gdata_player&v=yEwEv-2cjxk&desktop_uri=%2Fwatch%3Fv%3DyEwEv-2cjxk%26feature%3Dyoutube_gdata_player

Give you an idea of how badly I couldn't get it to hook up, turned tire to almost the 330ft mark on this run *shakes head* :dry:

Can't wait for some sticky rubber :)

Does it have an LSD?

Just a factory one ATM, was talking to Dan about 1.5 ways the other week. In saying that its still turning both wheels even so the old girl must not be to worn yet

yea mang. your gonna get some launch now boy! remember. soften up thos farking coils. and get mother f**king pineapples to twist your diff!

Yep, drag day tomorow will be on street tires again :(

0JPfzq6.png

Went 13.71 at 104, I think on the day as the track and car is that's about as fast as I could of went. There might be a bit more in it but just not on this set up.

Probley won't go back untill the new cam and stuff goes in :)

Not a bad time mate. :)

Thanks mate, I'm a little disappointed. I really thought it had a low 13 in it with this set up but apparently not.

In saying that I chopped a 2011 maloo ute by alot of car lengths aswell as an evo and a few other skylines on the day (also lost to an Audi r8 by 0.09 of a second across the line lol). I think alot of people think they're cars are faster "time wise" then what they are, I duno it cut a 13.7 and smashed alot if cars so what does that tell you.

Now.... Cam time :thumbsup:

.... 13.7 for a relatively stock ls1 in a reasonably heavy car is pretty good going. Your 33 is about the same weight as a commo with no interior or fat chicks. Most people have no idea how fast a flat 13 sec 1/4 really is.

N20 time... :yes:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Latest Posts

    • With ordering the belt, you're doing water pump and the idler and tensioner at the same time too yes?
    • This is just a dumb way of keeping the wastegate closed to make more boost. Undo it and either follow the factory setup or redo it properly. Manual boost controllers just use a spring preload to determine when to close in response to boost pressure so it no longer vents to atmosphere.
    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
×
×
  • Create New...